Search

This paper presents an investigation of the frictional behaviour of three-piece piston oil control rings. A bespoke tribometer replicates the kinematics of the contact between a full oil control ring and the cylinder liner. The three-piece oil control ring is composed of two segments, separated by a waveform-type expander. The experimental results indicate the dominance of a mixed regime of lubrication throughout the stroke. This is particularly the case when the experiments are conducted at 80 °C, a typical engine sump temperature, when compared with those at 20 °C (a typical engine start-up temperature in the UK in the summer). A mixed hydrodynamic analytical model of the oil control ring–cylinder liner tribological interface is employed to apportion frictional contributions with their physical underlying mechanisms. Therefore, combined numerical and experimental investigations are extended to lubricant contamination/dilution by ethanol-based fuels. This study shows that the transition from E10 to E85 would have an insignificant effect on the friction generated in the oil control ring conjunction. This holistic approach, using a detailed predictive l mixed regime of lubrication model and a representative bespoke tribometry, has not hitherto been reported in the open literature.

The Three-Piece Oil Control Ring (TPOCR) is becoming a viable option for heavy duty gas and hydrogen engines due to the low particle concentration in these engines. Although direct oil leakage from the gap is not likely to happen with the misalignment of the upper and lower rail gaps, there exist other less-apparent oil leaking mechanisms through the TPOCR. This work is targeted at understanding the oil leakage’s source and destination through the rail and liner interfaces across the whole cycle. The 2D Laser Induced Fluorescence technique was applied on an optical engine to study the oil transport behavior. Combined with a TPOCR model for dynamics and lubrication, the mechanisms that cause rail twist and oil scraping by the upper rail were analyzed. It was found that the symmetrical rail can scrape the oil up in the up-strokes. The scraped oil first accumulates in the clearance between the upper rail and groove, as well as at the upper corner of the rail Outer Diameter before being transferred to both the third land and liner when the piston changes direction at Top Dead Center. Rails with an asymmetrical profile can reduce or enhance these effects depending the orientation of the rails. This study provides findings that could help design the engine to better control Lubricate Oil Consumption and properly lubricate the Top Dead Center’s dry region at the same time.