Search

Electrical power system robustness is defined as the intrinsic capacity of an electrical power system to maintain assigned disturbance levels when external conditions change. This paper compares two methods for estimating voltage dip severity: the critical distance method and the fault position method. Their differences are not linked to the type of network but to the type of results which we are searching for. This paper proposes a graphical color visualization of the during fault voltage matrices that immediately correlates dip severity with colors defined by a proper scale. New robustness indices are also proposed to synthesize bus performance in terms of affected and exposed areas. Numerical applications refer to real transmission and real distribution systems. Index Terms--Power distribution, power quality (PQ), power system reliability, power transmission, voltage dips.

DC are furnaces are more and more applied in large industrial systems and represent one of the major sources of perturbations for the feeding system. This paper deals with the problem of the dc arc modeling using three well-known chaotic attractors (Rossler, Chua, and Lorenz attractors). A new tuning procedure is adopted to determine the most adequate parameters of the attractors to model the dc arc furnace. Waveform distortions and voltage fluctuations indexes are calculated from the simulation results of a whole existing plant and compared with measured data. The proposed models of dc arc furnace can be used to assess the impact in terms of power quality of the dc arc furnace when planning new plants or evaluating the performances of compensating devices. Index Terms--Chaotic models, DC arc furnaces, power quality.

The ac/dc/ac double-stage converter, frequently used nowadays to provide ac adjustable frequency and magnitude voltages in the adjustable-speed drives, consists of a voltage source inverter (VSI) fed by a three-phase diode bridge rectifier; this rectifier generates high line current harmonics in the supply system. This paper presents a complete modelling of the VSI-fed drives, when energized by nonsinusoidal supply voltages, based on the analytical form of the current harmonics injected in the supply system; the equations of the current harmonics are obtained for both the continuous and discontinuous current modes and are derived by Fourier analysis of steady-state current time evolution. The high accuracy of the proposed models is demonstrated by comparison with the results of time-domain simulation. The modelling is useful to study the effects of supply voltage distortions on current harmonics injected in the supply system, both in continuous and discontinuous mode, with a very short computing time. Index Terms--Harmonic modelling, voltage source inverter-fed drive.

Selection of cable size in the nonsinusoidal conditions is only based on ampacity considerations without any attention to the cost of the losses that will be suffered in the cable life. Since the cost of these losses (fundamental plus harmonics) can assume significant values, the selection of a cross section higher than required for ampacity considerations can result in a large reduction of cost. This paper proposes a method which allows the optimal economic selection of medium-voltage cables in nonsinusoidal operating conditions; it takes into account the initial investment costs and the Joule losses costs, including the additional costs due to current harmonics. It employs simplified expressions similar to those adopted by the IEC Standard in sinusoidal conditions, being the harmonic presence taken into account by a proper definition of a harmonic loss factor and by the introduction of harmonic coefficients to be predicted. Numerical applications to medium-voltage cables are developed and discussed in order to show the sensitivity of the cable optimum size to variations in the coefficients that characterize the harmonic presence. Index Terms--Cables, economics, harmonic distortion.