Search

We developed a near-infrared focused heating system (IRrDAC) for deformation experiments using a rotational diamond anvil cell. This study reports the results of annealing tests on silver and antigorite conducted at SPring-8 (BL47XU) using the IRrDAC system. The experimental results demonstrated the melting of silver and the dehydration of antigorite, confirming the capability of this system. The reproducible relationships between temperature and input power were also confirmed. The IRrDAC system enables deformation experiments at pressures equivalent to those of the lower mantle under homogeneous and stable temperatures and is expected to contribute to the understanding of deep Earth rheology., (© 2024 Author(s). Published under an exclusive license by AIP Publishing.)

Nearly all frictional interfaces strengthen as the logarithm of time when sliding at ultra-low speeds. Observations of also logarithmic-in-time growth of interfacial contact area under such conditions have led to constitutive models that assume that this frictional strengthening results from purely time-dependent, and slip-insensitive, contact-area growth. The main laboratory support for such strengthening has traditionally been derived from increases in friction during "load-point hold" experiments, wherein a sliding interface is allowed to gradually self-relax down to subnanometric slip rates. In contrast, following step decreases in the shear loading rate, friction is widely reported to increase over a characteristic slip scale, independent of the magnitude of the slip-rate decrease-a signature of slip-dependent strengthening. To investigate this apparent contradiction, we subjected granite samples to a series of step decreases in shear rate of up to 3.5 orders of magnitude and load-point holds of up to 10,000 s, such that both protocols accessed the phenomenological regime traditionally inferred to demonstrate time-dependent frictional strengthening. When modeling the resultant data, which probe interfacial slip rates ranging from 3 .[Formula: see text]. to less than [Formula: see text], we found that constitutive models where low slip-rate friction evolution mimics log-time contact-area growth require parameters that differ by orders of magnitude across the different experiments. In contrast, an alternative constitutive model, in which friction evolves only with interfacial slip, fits most of the data well with nearly identical parameters. This leads to the surprising conclusion that frictional strengthening is dominantly slip-dependent, even at subnanometric slip rates.

Nonvolcanic, deep low-frequency tremors and slow-slip events occur simultaneously in the transition zone from locked to continuously creeping fault in the down-dip portion of the Nankai Trough subduction zone, southwestern Japan. The occurrence of these slow earthquakes is discontinuous along the trench and attributed to the effect of high pore pressures at the plate boundary. Here, we show that spatial variations in intraslab stress may control fluid migration from the subducted Philippine Sea slab to the plate boundary. The triaxial normal faulting stress, detected by stress tensor inversion using focal mechanisms in the slab, controls anisotropically permeability that trends NNW-SSE subhorizontally from the subducted Philippine Sea slab to the plate boundary. The inhomogeneous permeability controlled by spatial stress heterogeneities in the subducted Philippine Sea slab controls the intraslab fluid pathway. This hypothesis is consistent with the spatial heterogeneity of slow earthquakes and 3 He/ 4 He ratio distributions.

Intermediate-depth earthquakes in cold subduction zones are observed within the subducting oceanic crust, as well as the mantle. In contrast, intermediate-depth earthquakes in hot subduction zones predominantly occur just below the Mohorovičić discontinuity. These observations have stimulated interest in relationships between blueschist-facies metamorphism and seismicity, particularly through dehydration reactions involving the mineral lawsonite. Here we conducted deformation experiments on lawsonite, while monitoring acoustic emissions, in a Griggs-type deformation apparatus. The temperature was increased above the thermal stability of lawsonite, while the sample was deforming, to test whether the lawsonite dehydration reaction induces unstable fault slip. In contrast to similar tests on antigorite, unstable fault slip (that is, stick-slip) occurred during dehydration reactions in the lawsonite and acoustic emission signals were continuously observed. Microstructural observations indicate that strain is highly localized along the fault (R1 and B shears), and that the fault surface develops slickensides (very smooth fault surfaces polished by frictional sliding). The unloading slope during the unstable slip follows the stiffness of the apparatus at all experimental conditions, regardless of the strain rate and temperature ramping rate. A thermomechanical scaling factor for the experiments is within the range estimated for natural subduction zones, indicating the potential for unstable frictional sliding within natural lawsonite layers.