Search

The results of recent laboratory experiments with wax extruded beneath relatively cold water may be extrapolated to predict the surface morphology of submarine lavas as a function of the extrusion rate and melt viscosity. The experiments with solidifying wax indicated that the surface morphology was controlled by a single parameter, the ratio of the time taken for the surface to solidify, and a time scale for lateral flow. For submarine basalts a solution of the cooling problem (which is dominated by conduction in the lava but convective heat transfer in the water) and estimates of lava viscosities place this parameter within the empirically determined 'pillowing' regime over a wide range of extrusion rates. This results is consistent with the observation that pillow basalts are the most common products of submarine eruptions. Smoother surfaces corresponding to the various types of submarine sheet flows are predicted for sufficiently rapid extrusion of basaltic magma. Still higher eruption rates in regions of low topographic relief may produce submarine lava lakes. Minimum emplacement times can be calculated for submarine volcanic constructs of a single lava flow type.

Computations are carried out of the rates of surface cooling and lateral flow of lavas extruded onto the surfaces of terrestrial planets and the outer planet satellites, and the likely flow morphologies predicted by extrapolation of the laboratory analog results are determined. Results of this approach are presented for the earth, Venus, Mars, the moon, and the silicate flows on Io. The experiments, which involved the spreading of a viscous liquid under gravity in the presence of a solidifying surface crust, revealed a set of four distinct surface morphologies.

Research suggests that variations in lava dome morphology on different planets will depend much more critically on local gravity and the style of eruption than on the magma composition, ambient temperature, or the relative roles of convective and radiative cooling. Eruption style in turn reflects differences in tectonic conditions and the ability of magma to exsolve volatiles. Observed crude correlations between silica content and calculated yield strengths for terrestrial lava flows and domes probably are do to differences in extrusion rate and volatile solubility, rather than intrinsic rheological properties. Thus, even after taking the known effect of gravity into account, observed differences in gross dome morphology on different planets cannot by themselves be directly related to composition. Additional information such as the distribution of surface textures and structures, or spectroscopic data will be needed to conclusively establish dome compositions.

In the present investigation of solidifying-crust effects on the dynamics and surface morphology of radial viscous-gravity currents, polyethylene glycol inflows into the base of a tank holding a cold sucrose solution are used as analogs. As the radial current advanced away from the inlet, its surface solidified and deformed through a combination of folding anf fracturing. When cooling was sufficiently rapid, solid crust formed and caused the spreading rate to increase; progressively colder experiments revealed a sequence of surface morphologies resembling features of cooling lava flows and lava lakes, including multiarmed rift structures with shear offsets and bulbous lobate forms resembling pillow lavas on the ocean floor.