Search

In this paper, we report enhanced breakdown characteristics of Pt/BaTiO3/Al0.58Ga0.42N lateral heterojunction diodes compared to Pt/Al0.58Ga0.42N Schottky diodes. BaTiO3, an extreme dielectric constant material, has been used, in this study, as dielectric material under the anode to significantly reduce the peak electric field at the anode edge of the heterojunction diode such that the observed average breakdown field was higher than 8 MV/cm, achieved for devices with anode to cathode spacing less than 0.2 microns. Control Schottky anode devices (Pt/Al0.58Ga0.42N) fabricated on the same sample displayed an average breakdown field around 4 MV/cm for devices with similar dimensions. While both breakdown fields are significantly higher than those exhibited by incumbent technologies such as GaN-based devices, BaTiO3 can enable more effective utilization of the higher breakdown fields available in ultra-wide bandgap materials by proper electric field management. This demonstration thus lays the groundwork needed to realize ultra-scaled lateral devices with significantly improved breakdown characteristics.

In this letter, we design and demonstrate an improved MOCVD grown reverse Al-composition graded contact layer to achieve low resistance contact to MOCVD grown ultra-wide bandgap (UWBG) Al0.70Ga0.30N channel metal semiconductor field-effect transistors (MESFETs). Increasing the thickness of the reverse graded layer was found to improve contact layer resistance significantly, leading to contact resistance of 3.3x10^-5 Ohm.cm2. Devices with gate length, LG, of 0.6 microns and source-drain spacing, LSD, of 1.5 microns displayed a maximum current density, IDSMAX, of 635 mA/mm with an applied gate voltage, VGS, of +2 V. Breakdown measurements on transistors with gate to drain spacing, LGD, of 770 nm had breakdown voltage greater than 220 , corresponding to minimum breakdown field of 2.86 MV/cm. This work provides a framework for the design of low resistance contacts to MOCVD grown high Al-content AlxGa1-xN channel transistors.

In this paper, we report enhanced breakdown characteristics of Pt/BaTiO3/Al0.58Ga0.42N lateral heterojunction diodes compared to Pt/Al0.58Ga0.42N Schottky diodes. BaTiO3, an extreme dielectric constant material, has been used, in this study, as dielectric material under the anode to significantly reduce the peak electric field at the anode edge of the heterojunction diode such that the observed average breakdown field was higher than 8 MV/cm, achieved for devices with anode to cathode spacing less than 0.2 microns. Control Schottky anode devices (Pt/Al0.58Ga0.42N) fabricated on the same sample displayed an average breakdown field around 4 MV/cm for devices with similar dimensions. While both breakdown fields are significantly higher than those exhibited by incumbent technologies such as GaN-based devices, BaTiO3 can enable more effective utilization of the higher breakdown fields available in ultra-wide bandgap materials by proper electric field management. This demonstration thus lays the groundwork needed to realize ultra-scaled lateral devices with significantly improved breakdown characteristics.

Beta-phase Ga2O3 has emerged as a promising candidate for a wide range of device applications, including power electronic devices, radio-frequency devices and solar-blind photodetectors. The wide bandgap energy and the predicted high breakdown field, together with the availability of low-cost native substrates, make \b{eta}-Ga2O3 a promising material compared to other conventional wide bandgap materials, such as GaN and SiC. Alloying of Al with \b{eta}-Ga2O3 could enable even larger band gap materials, and provide more flexibility for electronic and optoelectronic device design. In this work, we demonstrate a high mobility two-dimensional electron gas (2DEG) formed at the \b{eta}-(AlxGa1-x)2O3/Ga2O3 interface through modulation doping. Shubnikov-de Haas oscillation was observed for the first time in the modulation-doped \b{eta}-(AlxGa1-x)2O3/Ga2O3 structure, indicating a high-quality channel formed at the heterojunction interface. The formation of the 2DEG channel was further confirmed by a weak temperature-dependence of the carrier density, and the peak low temperature mobility was found to be 2790 cm2/Vs, which is significantly higher than can be achieved in bulk-doped \b{eta}-Ga2O3. The demonstrated modulation-doped \b{eta}-(AlxGa1-x)2O3/Ga2O3 structure lays the foundation for future exploration of quantum physical phenomena as well as new semiconductor device technologies based on the \b{eta}-Ga2O3 material system.

We show that density-dependent velocity saturation in a GaN High Electron Mobility Transistor (HEMT) can be related to the stimulated emission of longitudinal optical (LO) phonons. As the drift velocity of electrons increases, the drift of the Fermi distribution in reciprocal space produces population inversion and gain for the LO phonons. Once this gain reaches a threshold value, the avalanche-like increase of LO emission causes a rapid loss of electron energy and momentum and leads to drift velocity saturation. Our simple model correctly predicts both the general trend of the saturation velocity decreasing with increasing electron density and the values of saturation velocity measured in our experiments.

A high threshold voltage enhancement-mode GaN HEMT with p-type doped buffer is discussed and simulated. Analytical expressions are derived to explain the role of buffer capacitance in designing and enhancing threshold voltage. Simulations of the proposed device with p-type buffer show threshold voltages above 5 V, and a positive shift in threshold voltage as the oxide capacitance is reduced, thus enabling threshold voltage tunability over an unprecedented range for GaN-based HEMTs. The electric field profiles, breakdown performance, on-resistance and delay tradeoffs in the proposed pGaN back HEMT device are also discussed., Comment: 6 pages, 7 figures

We report on the direct measurement of two-dimensional sheet charge density dependence of electron transport in AlGaN/GaN high electron mobility transistors. Pulsed IV measurements established increasing electron velocities with decreasing sheet charge densities, resulting in saturation velocity of 1.9 x 10^7 cm/s at a low sheet charge density of 7.8 x 10^11 cm-2. A new optical phonon emission-based electron velocity model for GaN is also presented. It accommodates stimulated LO phonon emission which clamps the electron velocity with strong electron-phonon interaction and long LO phonon lifetime in GaN. A comparison with the measured density-dependent saturation velocity shows that it captures the dependence rather well. Finally, the experimental result is applied in TCAD-based device simulator to predict DC and small signal characteristics of a reported GaN HEMT. Good agreement between the simulated and reported experimental results validated the measurement presented in this report and established accurate modeling of GaN HEMTs., Comment: 11 pages, 7 figures

A high threshold voltage enhancement-mode GaN HEMT with p-type doped buffer is discussed and simulated. Analytical expressions are derived to explain the role of buffer capacitance in designing and enhancing threshold voltage. Simulations of the proposed device with p-type buffer show threshold voltages above 5 V, and a positive shift in threshold voltage as the oxide capacitance is reduced, thus enabling threshold voltage tunability over an unprecedented range for GaN-based HEMTs. The electric field profiles, breakdown performance, on-resistance and delay tradeoffs in the proposed pGaN back HEMT device are also discussed., 6 pages, 7 figures

We report on the potential of high electron mobility transistors (HEMTs) consisting of high composition AlGaN channel and barrier layers for power switching applications. Detailed 2D simulations show that threshold voltages in excess of 3 V can be achieved through the use of AlGaN channel layers. We also calculate the two-dimensional electron gas (2DEG) mobility in AlGaN channel HEMTs and evaluate their power figures of merit as a function of device operating temperature and Al mole fraction in the channel. Our models show that power switching transistors with AlGaN channels would have comparable on-resistance to GaN-channel based transistors for the same operation voltage. The modeling in this paper shows the potential of high composition AlGaN as a channel material for future high threshold enhancement mode transistors., Comment: 12 pages, 4 figures