Search

A newly designed DC–AC three phase bidirectional converter (DATBC) with an encapsulated DC–DC converter (EDC) for the energy storage system (ESD) is analysed and investigated in this research paper. By using encapsulated or embedded or hidden DC–DC converter a stable and constant DC bus is developed between the encapsulated DC–DC converter and DC–AC three phase bidirectional converter. The proposed converter is entirely different from the traditional dual-stage DC–AC converter, because it takes less than 20% of power used for the DC–AC conversion process. So, this reduced power consumption increases efficiency to a considerable value. A new control technique for zero sequence has been adopted components are inserted in the modulating signal based on carrier pulse width modulation (CPWM). Working principle, implementation and characteristics of the DC–AC three phase bidirectional converter are analysed. Effectiveness and feasibility of the developed converter are examined with a proto-type model. [ABSTRACT FROM AUTHOR]

This paper presents the design of a grid-connected hybrid system using modified Z source converter, bidirectional converter and battery storage system. The input sources for the proposed system are fed from solar and wind power systems. A modified high gain switched Z source converter is designed for supplying constant DC power to the DC-link of the inverter. A hybrid deep learning (HDL) algorithm (CNN-BiLSTM) is proposed for predicting the output power from the hybrid systems. The HDL method and the PI controller generate pulses to the proposed system. A closed loop control framework is implemented for the proposed grid integrated hybrid system. A 1.5 Kw hybrid system is designed in MATLAB/SIMULINK software and the results are validated. A prototype of the proposed system is developed in the laboratory and experimental results are obtained from it. From the simulation and experimental results, it is observed that the ANN controller with SVPWM (Space vector Pulse width Modulation) gives a THD (Total harmonic distortion) of 2.2% which is within the IEEE 519 standard. Therefore, from the results, it is identified that the ANN-SVPWM method injects less harmonic currents into the grid than the other two controllers. [ABSTRACT FROM AUTHOR]

Multilevel inverters (MLIs) are an imperative solution for high power and high voltage applications. The MLIs can be classified into two categories such as symmetric and asymmetric. The asymmetric type MLIs has large number of output voltage steps with less number of input DC voltage sources and switching devices. In this paper, a single phase asymmetric (trinary sequence DC source) Cascaded H-Bridge MLI has been developed using unipolar PWM control schemes. The topology can produce 27-level output voltage with the help of 12 switches and 3 DC sources. It has been examined with a diverse combination of multicarrier unipolar PWM control. The PWM control includes Phase Disposition (PDPWM), Alternative Opposition Disposition (APODPWM), Carrier overlapping (COPWM), and Variable Frequency (VFPWM). The harmonic content of output voltage for each technique has been observed with different modulation indices. The demonstration of proposed topology for generating 27-level output voltage has been tested through simulation in MATLAB-SIMULINK and verified with laboratory-based experimental setup. From the results, it is evident that the APODPWM offers quality output voltage with relatively low harmonic distortion. Also, it has been observed that COPWM performance is superior since it delivers relatively higher fundamental RMS output voltage. [ABSTRACT FROM AUTHOR]

Copyright of Automatika: Journal for Control, Measurement, Electronics, Computing & Communications is the property of Taylor & Francis Ltd and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

Copyright of Automatika: Journal for Control, Measurement, Electronics, Computing & Communications is the property of Taylor & Francis Ltd and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

Copyright of Automatika: Journal for Control, Measurement, Electronics, Computing & Communications is the property of Taylor & Francis Ltd and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

Copyright of Automatika: Journal for Control, Measurement, Electronics, Computing & Communications is the property of Taylor & Francis Ltd and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)