Search

The high-temperature non-equilibrium effect is a novel and significant issue in the flows over a high Mach number (above Mach 8) air-breathing vehicle. Thus, this study attempts to investigate the high-temperature non-equilibrium flows of a curved compression two-dimensional scramjet inlet at Mach 8 to 12 utilizing the two-dimensional non-equilibrium RANS calculations. Notably, the thermochemical non-equilibrium gas model can predict the actual high-temperature flows, and the numerical results of the other four thermochemical gas models are only used for comparative analysis. Firstly, the thermochemical non-equilibrium flow fields and work performance of the inlet at Mach 8 to 12 are analyzed. Then, the influences of high-temperature non-equilibrium effects on the starting characteristics of the inlet are investigated. The results reveal that a large separation bubble caused by the cowl shock/lower wall boundary layer interaction appears upstream of the shoulder, at Mach 8. The separation zone size is smaller, and its location is closer to the downstream area while the thermal process changes from frozen to non-equilibrium and then to equilibrium. With the increase of inflow Mach number, the thermochemical non-equilibrium effects in the whole inlet flow field gradually strengthen, so their influences on the overall work performance of the high Mach number inlet are more obvious. The vibrational relaxation or thermal non-equilibrium effects can yield more visible influences on the inlet performance than the chemical non-equilibrium reactions. The inlet in the thermochemical non-equilibrium flow can restart more easily than that in the thermochemical frozen flow. This work should provide a basis for the design and starting ability prediction of the high Mach number inlet in the wide operation range.

By introducing an open stub loaded resonator (OSLR) and a uniform impedance resonator (UIR) into balanced stepped-impedance microstrip-slotline transition structures, a balanced dual-band bandpass filter (BPF) with high selectivity and low insertion loss performance is presented in this paper. The balanced microstrip-slotline transition structures can achieve a wideband common-mode (CM) suppression. Meanwhile, the differential-mode (DM) passbands are independent from the CM responses, which greatly simplifies the design procedure. In addition, four varactors are loaded into OSLR and UIR to achieve the electrical reconfiguration. The proposed balanced dual-band BPF can realize quasi-independently tunable center frequencies and bandwidths. In order to verify the feasibility of the proposed design method, a prototype circuit of the proposed reconfigurable balanced dual-band BPF is simulated, fabricated and measured. A good agreement between the simulation and measurement results is observed.