Search

Background: Placement of clamp forceps along the transsyndesmotic (TS) axis reduces the risk of iatrogenic syndesmotic malreduction during ankle fracture surgery with tibiofibular diastasis. This study aimed to measure the difference between the TS axis and the axis determined by an intraoperative fluoroscopic technique using the center-center (CC) method. We also compared the values obtained when the CC method was performed at different heights from the tibial plafond. Methods: We evaluated the computed tomography scans of 150 patients with normal syndesmosis. The CC method was simulated using digitally reconstructed radiographs. The TS and CC axes were projected onto an axial computed tomographic image linked to digitally reconstructed radiography. The angle between the two axes (interaxis angle) and the distance between the intersection of these axes and the medial tibial cortex (interaxis distance) were measured. The procedures were performed 0, 10, and 20 mm proximal to the tibial plafond, and the measurements were compared among the different heights using a 1-way repeated-measures analysis of variance. Results: The TS axis was found to be externally rotated to the CC axis, with an interaxis angle of 8.5 degrees (SD, 6.8 degrees). The interaxis angle increased from 1.9 degrees at a height of 0 mm to a greater angle at higher heights (P <.001). The overall interaxis distance was 7.7 (SD, 6.3) mm, increasing from 2.0 mm at a height of 0 mm to a greater distance at higher heights (P <.001). Conclusion: The TS axis was externally rotated relative to the CC axis, and the difference between the 2 axes was greater when the CC method was performed on the higher heights from the tibial plafond. To clamp the syndesmosis along the TS axis, the CC method should be applied close to the ankle joint. Level of Evidence: Level IV, case series. [ABSTRACT FROM AUTHOR]

We report the case of a 31-year-old male who presented with traumatic dislocation of both proximal and distal tibiofibular joints without fibular fracture. The patient underwent closed reduction of the proximal tibiofibular joint and surgical stabilization of the distal tibiofibular joint. An 18-month postoperative evaluation confirmed a very good clinical outcome after anatomic reduction. This type of trauma is very rare and, to our knowledge, has only been described 3 times previously. Furthermore, our surgical management was different from that used for the previous cases and proved to be satisfactory. [ABSTRACT FROM AUTHOR]

Syndesmotic injuries of the ankle commonly occur by an external rotation force applied to the ankle joint. Ten fresh-frozen lower extremities from cadavers were used. A specially designed apparatus was used to stabilize the specimen and rotate the ankle joint from internally rotated 25° to externally rotated 35° at a rate of 6°/s for 10 cycles. Two stages were tested (stage I, specimens intact; and stage II, simulated pronation external rotation type injury with fixation). Group 1 was fixed with a novel suture construct across the syndesmotic joint, and group 2 was fixed with a single metallic screw. The torque, rotational angle, and 3-dimensional syndesmotic diastasis readings were recorded. Three-dimensional tibiofibular diastasis was identified. The fibula of the intact specimens displaced an average of 8.6 ± 1.7, 2.4 ± 1.0, and 1.4 ± 1.0 mm in the anterior, lateral, and superior direction, respectively, when the foot was externally rotated 35°. The sectioning of the syndesmostic ligaments and deltoid ligament resulted in a significant decrease in syndesmotic diastasis and foot torsional force ( p < .05). The ligament-sectioned specimen lost 57% (externally rotated) and 17% (internally rotated) torsional strength compared with the intact specimen. Groups 1 and 2 provided similar biomechanical stability in this cadaveric model of a syndesmosis deficiency. [ABSTRACT FROM AUTHOR]