Search

This paper investigates the resource scheduling for heterogeneous vehicular networks, where some moving vehicles are selected and scheduled as helping relays to assist information transmission between the roadside infrastructure and other moving vehicles. For such a system, we propose a mobile-service based max-min fairness resource scheduling scheme, where service amount which is more suitable for high mobility scenarios is adopted to characterize the information transmission capacity of the links and the max-min criteria is adopted to meet the fairness requirement of the moving vehicles. Simulation results demonstrate the effectiveness of our proposed scheme. It is shown that our proposed scheme archives higher throughput and better fairness compared with random scheduling scheme and non relaying scheme., Comment: 5 Figures, published by IEEE China Communications, Supplement 2015, 10-18

This paper investigates the simultaneous wireless information and power transfer (SWIPT) in cooperative relay networks, where a relay harvests energy from the radio frequency (RF) signals transmitted by a source and then uses the harvested energy to assist the information transmission from the source to its destination. Both source and relay transmissions use rateless code, which allows the destination to employ any of the two information receiving strategies, i.e., the mutual information accumulation (IA) and the energy accumulation (EA). The SWIPT-enabled relay employs three different SWIPT receiver architectures, the ideal receiver and two practical receivers (i.e., the power splitting (PS) and the time switch (TS) receivers). Accordingly, three relaying protocols, namely, ideal protocol, PS protocol and TS protocol, are presented. In order to explore the system performance limits with these three protocols, optimization problems are formulated to maximize their achievable information rates. For the ideal protocol, explicit expressions of the optimal solutions are derived. For the PS protocol, a linear-search algorithm is designed to solve the non-convex problems. For the TS protocol, two solving methods are presented. Numerical experiments are carried out to validate our analysis and algorithms, which also show that, with the same SWIPT receiver, the IA-based system outperforms the EA-based system, while with the same information receiving strategy, PS protocol outperforms TS protocol. Moreover, compared with conventional non-SWIPT and non-rateless-coded systems, the proposed protocols exhibit considerable performance gains, especially in relatively low signal-to-noise ratio (SNR) regime. Besides, the effects of the source-destination direct link and the relay position on system performance are also discussed, which provides insights on SWIPT-enabled relay systems., Comment: 31 pages,15 figures, submitted to IEEE Journal

This paper investigates the simultaneous wireless information and power transfer (SWIPT) for two-hop orthogonal frequency division multiplexing (OFDM) decode-and-forward (DF) relay communication system, where a relay harvests energy from radio frequency signals transmitted by the source and then uses the harvested energy to assist the information transmission from the source to its destination. The power splitting receiver is considered at the relay, which splits the received signal into two power streams to perform information decoding (ID) and energy harvesting (EH) respectively. For better understanding the behavior and exploring the performance limit of such a system, resource allocation is studied to maximize the total achievable transmission rate. An optimization problem, which jointly takes into account the power allocation, the subcarrier pairing and the power splitting, is formulated. Due to its non-convexity, a resource allocation policy with low complexity based on separation principle is designed. Simulation results show that the system performance can be significantly improved by using our proposed policy. Moreover, the system performance behavior to the relay position is also discussed, and results show that in the two-hop OFDM system with EH relay, the relay should be deployed near the source, while in that with conventional non-EH relay, it should be deployed at the middle between the source and the destination., Comment: 18 pages, 6 figures