Search

A fundamental challenge of the quantum revolution is to efficiently interface the quantum computing systems operating at cryogenic temperatures with room temperature electronics and media for high data-rate communication. Current approaches to control and readout of such cryogenic computing systems use electrical cables, which prevent scalability due to their large size, heat conduction, and limited bandwidth1. A more viable approach is to use optical fibers which allow high-capacity transmission and thermal isolation. A key component in implementing photonic datalinks is a cryogenic optical modulator for converting data from the electrical to the optical domain at high speed and with low power consumption, while operating at temperatures of 4 K or lower. Cryogenic modulators based on the electro-optic effect have been demonstrated in a variety of material platforms, however they are voltage driven components while superconducting circuits are current based, resulting in a large impedance mismatch. Here, we present the first demonstration of an integrated current-driven modulator based on the magneto-optic effect operating over a wide temperature range that extends down to less than 4 K. The modulator works at data rates up to 2 Gbps with energy consumption below 4 pJ/bit, and we show that this figure can be reduced to less than 40 fJ/bit with optimized design and fabrication. This modulator is a hybrid device, where a current-driven magneto-optically active crystal (cerium substituted yttrium iron garnet, or Ce:YIG) is bonded to a high-quality silicon microring resonator. Because of its potential for extremely low power consumption under cryogenic conditions, the class of magneto-optical modulators demonstrated here has the potential to enable efficient data links in large-scale systems for quantum information processing., Comment: Single pdf file

Networks inside current data centers comprise a hierarchy of power-hungry electronic packet switches interconnected via optical fibers and transceivers. As the scaling of such electrically-switched networks approaches a plateau, a power-efficient solution is to implement a flat network with optical circuit switching (OCS), without electronic switches and a reduced number of transceivers due to direct links among servers. One of the promising ways of implementing OCS is by using tunable lasers and arrayed waveguide grating routers. Such an OCS-network can offer high bandwidth and low network latency, and the possibility of photonic integration results in an energy-efficient, compact, and scalable photonic data center network. To support dynamic data center workloads efficiently, it is critical to switch between wavelengths in sub nanoseconds (ns). Here we demonstrate ultrafast photonic circuit switching based on a microcomb. Using a photonic integrated Si3N4 microcomb in conjunction with semiconductor optical amplifiers (SOAs), sub ns (< 500 ps) switching of more than 20 carriers is achieved. Moreover, the 25-Gbps non-return to zero (NRZ) and 50-Gbps four-level pulse amplitude modulation (PAM-4) burst mode transmission systems are shown. Further, on-chip Indium phosphide (InP) based SOAs and arrayed waveguide grating (AWG) are used to show sub-ns switching along with 25-Gbps NRZ burst mode transmission providing a path toward a more scalable and energy-efficient wavelength-switched network for future data centers., Comment: 11 pages, 6 figures

We present a pilot-assisted coherent intradyne reception methodology for CV-QKD with true local oscillator. An optically phase-locked reference tone, prepared using carrier-suppressed optical single-sideband modulation, is multiplexed in polarisation and frequency to the 250 Mbaud quantum signal in order to provide optical frequency- and phase matching between quantum signal and local oscillator. Our concept allows for high symbol rates and can be operated at an extremely low excess-noise level, as validated by experimental measurements., Comment: 12 pages, 6 figures, 1 table