Search

The catalytic sites of MoS$_{2}$ monolayers towards hydrogen evolution are well known to be vacancies and edge-like defects. However, it is still very challenging to control the position, size, and defective areas on the basal plane of Mo$S_{2}$ monolayers by most of defect-engineering routes. In this work, the fabrication of etched arrays on ultra-large supported and free-standing MoS$_{2}$ monolayers using focused ion beam (FIB) is reported for the first time. By tuning the Ga+ ion dose, it is possible to confine defects near the etched edges or spread them over ultra-large areas on the basal plane. The electrocatalytic activity of the arrays toward hydrogen evolution reaction (HER) was measured by fabricating microelectrodes using a new method that preserves the catalytic sites. We demonstrate that the overpotential can be decreased up to 290 mV by assessing electrochemical activity only at the basal plane. High-resolution transmission electron microscopy images obtained on FIB patterned freestanding MoS$_{2}$ monolayers reveal the presence of amorphous regions and X-ray photoelectron spectroscopy indicates sulfur excess in these regions. Density-functional theory calculations provide identification of catalytic defect sites. Our results demonstrate a new rational control of amorphous-crystalline surface boundaries and future insight for defect optimization in MoS$_{2}$ monolayers., Comment: 10 pages, 5 figures

We address a novel method for analytical determinations that combines simplicity, rapidity, low consumption of chemicals, and portability with high analytical performance taking into account parameters such as precision, linearity, robustness, and accuracy. This approach relies on the effect of the analyte content over the Gibbs free energy of dispersions, affecting the thermodynamic stabilization of emulsions or Winsor systems to form microemulsions (MEs). Such phenomenon was expressed by the minimum volume fraction of amphiphile required to form microemulsion, which was the analytical signal of the method. The performed studies were: phase behavior, droplet dimension by dynamic light scattering, analytical curve, and robustness tests. The reliability of the method was evaluated by determining water in ethanol fuels and monoethylene glycol in complex samples of liquefied natural gas. The dispersions were composed of water-chlorobenzene (water analysis) and water-oleic acid (monoethylene glycol analysis) with ethanol as the hydrotrope phase. The experiments to determine water demonstrated that the analytical performance depends on the composition of ME. The linear range was fairly broad with limits of linearity up to 70.00% water in ethanol. For monoethylene glycol in water the linear range was observed throughout the volume fraction of analyte. The natural gas samples provided by the Petrobras exhibited color, particulate material, high ionic strength, and diverse compounds as metals, carboxylic acids, and anions. The method allowed accurate measures bypassing steps such as extraction, preconcentration, and dilution of the sample. In addition, the levels of robustness were promising. This parameter was evaluated by investigating the effect of (i) deviations in volumetric preparation of the dispersions and (ii) changes in temperature over the analyte contents recorded by the method., Comment: 9 pages (paper) + 12 pages (Supplementary Information included), 7 figures (paper) + 6 figures (S. I.)