Search

Microwire solar cells have demonstrated promising optical and photovoltaic performance in arrays of single junction Si wires. Seeking higher efficiencies, we have numerically investigated III-V on Si 1−x Ge x architectures as candidates for tandem microwire photovoltaics via optical and electronic transport modeling. Optical modeling indicates that light trapping is an important design criterion. Absorption is more than doubled by the presence of Al 2 O 3 scattering particles around the wires, leading to high overall light collection despite low wire packing fraction. Texturing of the microwire outer surface, which was found to occur experimentally for GaP/Si microwires, is also shown to enhance absorption by over 50% relative to wires with smooth surfaces, allowing for the use of thinner layers. Finally, full optoelectronic simulations of GaAs on Ge structures revealed that current matching is attainable in these structures and that wire device efficiencies can approach those of planar cells.

Silicon microwire arrays have recently demonstrated their potential for low cost, high efficiency photovoltaics. These high aspect ratio, radial junction wire arrays allow for the absorption of nearly all the incident sunlight while enabling efficient carrier extraction in the radial direction. One of the remaining challenges to make this technology commercially viable is scaling up of the microwire array growth. We discuss here a technique we have developed for vapor liquid solid growth of microwire arrays over full six-inch wafers using a cold-wall RF-heated chemical vapor deposition furnace. This geometry allows for fairly uniform growth over large areas, rapid cycle time, and improved run-to-run reproducibility. We have studied these large-area microwire arrays using scanning electron microscopy and confocal microscopy to assess their structural fidelity and uniformity. We have also developed a technique to embed these large-area arrays in polymer and peel them off the substrate, which could enable lightweight, flexible solar cells with efficiencies as high as crystalline Si solar cells. We have tested the energy conversion properties of these microwire array samples grown using a liquid junction contact and a photoelectrochemical cell. Initial efficiencies measured in this way suggest that the material quality of these microwire arrays is similar to earlier small-area wire arrays that we have grown, meaning that this technique is a viable way to scale up microwire array devices.