Search

Perovskite solar cells (PSCs) are promising technology for flexible photovoltaic applications because of the low cost and good flexibility of the halide perovskite materials. Nevertheless, the use of transparent conductive oxides (TCOs) and noble metals (e.g., Au and Ag) as PSC electrodes is very costly, and TCOs are too brittle for flexible applications. How to fabricate flexible PSCs (FPSCs) with cost-effective and soft electrode materials remains to be a big challenge. Herein, we report the first study of FPSCs using low-cost Cu electrodes. Both the transparent bottom electrode and the opaque top electrode are fabricated with Cu. FPSCs made with such Cu electrodes acquire a champion efficiency of 13.58% (Jsc of 17.79 mA cm-2, Voc of 1.031 V, and FF of 74.07%), which retains over 90% after 1000 cycles of bending at a small radius of curvature of 5 mm. The device shows negligible changes in Voc and FF after storage for 10 weeks without encapsulation.

Organometallic lead halide perovskites are excellent light harvesters for high-efficiency photovoltaic devices. However, as the key component in these devices, a perovskite thin film with good morphology and minimal trap states is still difficult to obtain. Herein we show that by incorporating a low boiling point alkyl halide such as iodomethane (CH3I) into the precursor solution, a perovskite (CH3NH3PbI3-xClx) film with improved grain size and orientation can be easily achieved. More importantly, these films exhibit a significantly reduced amount of trap states. Record photoluminescence lifetimes of more than 4 μs are achieved; these lifetimes are significantly longer than that of pristine CH3NH3PbI3-xClx films. Planar heterojunction solar cells incorporating these CH3I-mediated perovskites have demonstrated a dramatically increased power conversion efficiency compared to the ones using pristine CH3NH3PbI3-xClx. Photoluminescence, transient absorption, and microwave detected photoconductivity measurements all provide consistent evidence that CH3I addition increases the number of excitons generated and their diffusion length, both of which assist efficient carrier transport in the photovoltaic device. The simple incorporation of alkyl halide to enhance perovskite surface passivation introduces an important direction for future progress on high efficiency perovskite optoelectronic devices.

11-Mercaptoundecanoic acid (MUA)-stabilized gold nanoparticles (AuNPs) embedded in copper phthalocyanine (CuPc) were used as a buffer layer between a poly(3-hexyl-thiophene) (P3HT)/[6,6]-phenyl C61-butyric acid methyl ester (PCBM) bulk heterojunction and anodic indium-tin oxide (ITO) substrate. As systematic synchrotron-based grazing incidence X-ray diffraction (GIXRD) experiments demonstrated that the AuNPs present in the buffer layer can improve the microstructure of the active layer with a better lamella packing of P3HT from the surface to the interior, UV-visible absorption spectrum measurements revealed enhanced optical absorption due to the localized surface plasma resonance (LSPR) generated by the AuNPs. The device of ITO/poly(3,4-ethylenedioxythiophene):polystyrenesulfonate/CuPc:MUA-stabilized AuNPs/P3HT:PCBM/LiF/Al was found with over 24% enhancement of power conversion efficiency (PCE) in comparison with reference devices without AuNPs. This remarkable improvement in PCE should be partially attributed to LSPR generated by the AuNPs and partially to improved crystallization as well as preferred orientation order of P3HT due to the presence of the AuNPs, which would promote more applications of metal NPs in the organic photovoltaic devices and other organic multilayer devices.