Search

The widespread application of thermoelectric (TE) technology demands high‐performance materials, which has stimulated unceasing efforts devoted to the performance enhancement of Bi2Te3‐based commercialized thermoelectric materials. This study highlights the importance of the synthesis process for high‐performance achievement and demonstrates that the enhancement of the thermoelectric performance of (Bi,Sb)2Te3 can be achieved by applying cyclic spark plasma sintering to BixSb2–xTe3‐Te above its eutectic temperature. This facile process results in a unique microstructure characterized by the growth of grains and plentiful nanostructures. The enlarged grains lead to high charge carrier mobility that boosts the power factor. The abundant dislocations originating from the plastic deformation during cyclic liquid phase sintering and the pinning effect by the Sb‐rich nano‐precipitates result in low lattice thermal conductivity. Therefore, a high ZT value of over 1.46 is achieved, which is 50% higher than conventionally spark‐plasma‐sintered (Bi,Sb)2Te3. The proposed cyclic spark plasma liquid phase sintering process for TE performance enhancement is validated by the representative (Bi,Sb)2Te3 thermoelectric alloy and is applicable for other telluride‐based materials. [ABSTRACT FROM AUTHOR]

GeTe and (Bi,Sb)2Te3 are two representative thermoelectric (TE) materials showing maximum performance at middle and low temperature, respectively. In order to achieve higher performance over the whole temperature range, their segmented one‐leg TE modules are designed and fabricated by one‐step spark plasma sintering (SPS). To search for contact and connect layers, the diffusion behavior of Fe, Ni, Cu, and Ti metal layers in GeTe is studied systematically. The results show that Ti with a similar linear expansivity (10.80 × 10−6 K−1) to GeTe, has low contact resistance (3 µΩ cm2) and thin diffusion layer (0.4 µm), and thus is an effective metallization layer for GeTe. The geometric structure of the GeTe/(Bi,Sb)2Te3 segmented one‐leg TE module and the ratio of GeTe to (Bi,Sb)2Te3 are determined by finite element simulation method. When the GeTe height ratio is 0.66, its theoretical maximum conversion efficiency (ηmax) can reach 15.9% without considering the thermal radiation and thermal/electrical contact resistance. The fabricated GeTe/(Bi,Sb)2Te3 segmented one‐leg TE module showed a ηmax up to 9.5% with a power density ≈ 7.45 mW mm−2, which are relatively high but lower than theoretical predictions, indicating that developing segmented TE modules is an effective approach to enhance TE conversion efficiency. [ABSTRACT FROM AUTHOR]