Search

This research used bagasse as raw material, through xylanase biological treatment process, preparative bagasse dissolving pulp. The optimum process conditions of sulfuric acid pre-hydrolysis were as below: Acid dosage 0.10%, 150°C, 90min. After pre-hydrolysis, cellulose content of the raw materials increased 18.45%, and pentosan decreased 14.49%. The fiber quality analysis showed fiber length and width were reduced, the tiny fiber content was decreased after acid pre-hydrolysis; HPLC analysis showed the optimum acid pre-hydrolysis process which can reduce the inevitable cellulose degradation effectively,hemicelluloses were hydrolyzed furthest at the same time; FTIR spectrum analysis showed acid pre-hydrolysis process can dissolve a lot of hemicelluloses.

Microcapsules were prepared using the complex coacervation method with nano anatase TiO2 as the core material, gelatin/Arabia gum as the wall material, while dispersing TiO2 into the reaction solution using the ultrasonic. The prepared microcapsules can be finished into textiles such as the polypropylene nonwovens, and the microcapsules in the textiles gradually fracture and the anatase TiO2 was released, which would facilitate photo-degradation of the polypropylene nonwovens when exposed in sunlight. The microcapsules size was used as the process optimization evaluation index, and the quadratic general revolving combination design was used to conduct the experiments for obtaining the optimum ultrasonic conditions, and the other progress parameters were the same that used in our early microcapsule preparation. The obtained optimal process for ultrasound is: ultrasonic time is 17min; ultrasonic power is 74W and ultrasound temperature 60 °C.

By using Solidworks, a three-dimensional solid model of the wind turbine gearbox is established. Use Spring element in ANSYS joins transmission system and case structure system, the whole gearbox coupling dynamic model is built up and the first 20-order bound mode of the gearbox is calculated. Through modal analysis and experimental test show that the structure of wind turbine gearbox is reasonable, and resonance wouldn’t occur during the operational process, ensure the reliability of the unit operation and that for the wind turbine gearbox structure design to provide the theoretical basis.

Since the “plastic limit order” was released, shopping bags made of polypropylene spun-bonded nonwovens have been wildly used in daily life for their portability and recyclability. However, polypropylene materials are difficult to be degraded in natural conditions, thus they are not the “real” environmental protection bags. Many studies demonstrate that TiO2 has obvious effects on raising nonwovens’ photo-catalytic degradation rate. In this study, the microcapsules were prepared with complex coacervation method using chitosan and acacia as wall and TiO2 as core material. In addition, the main process parameters including the concentration of chitosan, PH of the coacervation solution and stirring speed, which have effects on the microcapsule formation behavior were discussed specially. The results show that the good microcapsules were produced at the condition of the chitosan concentration of 0.4%, the PH valued about 3.18, stirring speed of 300r/min, temperature of the coacervation 60°Cand the condensation reaction time for 15 minutes.

The chemical composition of various parts of banana stem and leaf were analysed. The soda cooking and kraft cooking process of banana stem were optimized. The bleaching performance of the banana stem pulp was discussed. The results showed that the banana stem and leaf kraft pulp were good fiber material for pulping and papermaking. The brightness of banana stem bleached pulp can reach above 80%ISO through ClO2 bleaching.

This paper introduces a modified financial chaotic system. Some basic dynamical properties are studied. Based on Lyapunov stability theory and LMI (linear matrix inequality), sufficient condition for the synchronization has been analyzed theoretically. Numerical simulations are given to show the effectiveness of this method.

The effects of the dosage of enzyme, liquid/solid ratio, reaction temperature, PH value and reaction time on enzymolysis and saccharification of bagasse pith were studied. The results showed that the optimum conditions of enzymatic hydrolysis of cellulase were PH 5.0,the dosage of enzyme 0.005g/g (oven dry pulp), liquid/solid ratio 35:1, 50°C and s 60h. The changes of bagasse pith during reacting were analyzed through HPLC and FIRT, it were found that the content of xylose increased and improve the yield of reducing sugar in hyrolysis by double-enzymatic(cellulase and lxyanase). The results of FTIR analysis showed that new chemical construction and functional groups were not generated.