Search

A full scale masonry model of two-floor and single bay was built in this paper and was strengthened by ring-beam and constructional column. And then pseudo-dynamic testing was conducted to study the time-history curves of displacement, velocity, acceleration response and restoring force in 7 degree rarely earthquake. Results show that the earthquake performance is steady and there are no visible cracks on the model after the testing. Windows and doors perform well because of the constraint of ring-beam and column, whereas failures often occurred when the structures were not strengthened. Seismic performance is largely improved by ring-beam and constructional column and the structure can resist 7 degree rarely earthquake.

Modulus of elasticity is an important mechanical parameter in analysis and design of reinforce concrete structures. The present value of modulus of elasticity ，which has rare relation with ratio of reinforcement ，is based on plain concrete. Authors deduced an equation between modulus of elasticity and ratio of reinforcement, and then an experimental study was conducted on 11 groups’ component of reinforce concrete with different ratio of reinforcement. At last, an equation for modulus of elasticity of different ratio of reinforcement determined by regression, using least squared method, was described. A cantilever, whose dynamic characteristics and response were calculated, was taken as an example to analyze influence of ratio of reinforcement on the structural analysis .Result shows that ratio of reinforcement has effect on modulus of elasticity . Moreover, if general modulus is ignored when calculate dynamic response, it will cause deviation.

Polybenzimidazole (PBI) with a high molecular weight of 69,000 was first synthesized. It was afterwards grafted with benzimidazole pendant groups on the backbones. The acid doped benzimidaozle grafted PBI membranes were investigated and characterized including fuel cell tests at elevated temperatures without humidification. At an acid doping level of 13.1 mol H3PO4 per average molar repeat unit, the PBI membranes with a benzimidazole grafting degree of 10.6% demonstrated a conductivity of 0.15 S cm-1 and a H2-air fuel cell peak power density of 378 mW cm-2 at 180 °C at ambient pressure without humidification.

Through the laboratory experiment, the foaming properties of six kinds of foaming agent was evaluated comprehensively. Through the primary selection, foaming agent concentration selection and salt tolerance evaluation, HY-2 foaming agent was selected in follow-up experiments. The Liquid viscosity effect for foaming performance showed that there exists an optimal value of the liquid viscosity, corresponding to the concentration of foam stabilizing agent should not be less than 700mg/l. The impact of temperature on the performance of foaming agent was mainly on the foam stability, the higher the temperature, the stability of the bubble the worse. Due to the presence of crude oil, foaming volume and stability of the foam appeared a downward trend, the character of which is very advantageous to adjust fluidity difference between the layers of high permeable formation and low permeable formation.

The Cobalt (Ⅱ) Complex constructed with 5-nitroisophthalic acid and 2,2’-bibenzimidazole, [Co(H2bibim)2( 5-nipa)] (1), (H2bibim =2,2’-bibenzimidazole, 5-nipa=5-nitroisophthalic acid) have been synthesized by hydrothermal methods and structurally characterized by elemental analysis, IR and X-ray single crystal diffraction. Complex 1 has six coordinated by two H2bibim ligands and one 5-nitroisophthalic acid groups that is further connected though intermolecular hydrogen bonds and resulting in a three-dimensional (3D) network.

The Cobalt (II) Complex constructed with 5-nitroisophthalic acid and 2,2’-bibenzimidazole, [Co(H2bibim)3](5-nipa)•H2O (1), (H2bibim =2,2’-bibenzimidazole, 5-nipa=5-nitroisophthalic acid) have been synthesized by hydrothermal methods and structurally characterized by elemental analysis, IR and X-ray single crystal diffraction. Complex 1 possesses distorted CoN6 octahedrals linked by the H2bibim ligands in a bidentate chelating mode and the 5-nitroisophthalic acid groups act as counterions, and there exists a 2D supramolecular network linked by intermolecular O−H•••O and N−H•••O hydrogen-bonding interactions.

A novel three dimensional reconstruction framework from wide baseline images was proposed based on point and line features. After detecting and matching features, the relations between discrete images are computed and refined according to multi-view geometric constraints, and both structure of the scene and motion of cameras are retrieved, where we employ a procedure of Euclidean reconstruction based on approximate camera internal parameters and buddle adjustments. Based on retrieved motion and correspondence of line features, a 3D line reconstruction scheme was put forward to assist us in gaining regular structure and topology of the scene. In virtue of some manual interactions, mesh models of the scene came into being, and a rectification method for perspective images was used to acquiring texture patches. Finally, an interactive modeling prototype system from multiple images is designed and implemented. Real scenes and augmented reality applications demonstrate the feasibility, correctness and accuracy of our framework.