Search

This paper presents the numerical analysis of prestressed reinforced concrete (PRC) beams strengthened with near-surface mounted (NSM) carbon fiber reinforced polymers (CFRP). ABAQUS finite element software was used to simulate the existing test beams to investigate the flexural behaviors of PRC beams strengthened with NSM CFRP strips. The finite element model of beams strengthened with NSM CFRP strips was established. The finite element calculation results were compared with the experimental results to verify the accuracy and effectiveness of the model. Based on this model, the influences of concrete strength grade and amount of CFRP strips on the flexural behaviors of directly strengthened beams and the cycle numbers and overload amplitude on the flexural behaviors of damaged strengthened beam were further analyzed, and the load-carrying capacity calculation formula of PRC beam strengthened with NSM CFRP strips was established. The results showed that the simulation results and the theoretical calculation were consistent with the test results. With the increase of concrete strength grade and amount of CFRP strips, the ultimate load of directly strengthened beams increased significantly, with a maximum increase of 21.3% and 23.0%, respectively. When the concrete strength grade exceeded C50, the improvement of the ultimate load was limited. When the overload amplitude was less than 60% of the ultimate load, the cycle numbers (within 500 times) had little effect on the yield load, ultimate load, and deformation. When the overload amplitude was higher than 60% of the ultimate load, the deformation increased, and the ultimate load decreased with the increase of the cycle numbers. The larger the overload amplitude, the smaller the ultimate load, and the larger the deformation under the same cycle numbers. [ABSTRACT FROM AUTHOR]

The objective of this study is to examine the performance of the shallow reinforced concrete foundation of a large-scale wind turbine under the influence of environmental loads. A 2 MW horizontal-axis onshore wind turbine supported by a shallow concrete foundation was considered. The foundation stresses, foundation settlements, and static and dynamic contact pressures at various positions of the shallow foundation were monitored from the construction phase to the operation phase in the field. Numerical simulations were also performed to further analyze the behavior of the wind turbine foundation in different cases. The results demonstrate that the responses of the reinforced concrete foundation, i.e., foundation stresses, contact pressures, and foundation settlements, were variables closely related to the wind direction and wind speed. The distribution of foundation stresses suggested that a reasonable design of steel reinforcement cages around the foundation steel ring is important. The dynamic contact pressure of the foundation could reach 5 kPa, so the influence of dynamic wind loads on the foundation response could not be always neglected, particularly for the foundations seated on weak soils. The foundation settlement during the operation phase could be characterized by the logistic model, but its distribution was uneven due to the presence of eccentric upper weight and wind load. The findings would provide guidance for the foundation design of onshore wind turbines in hilly areas. [ABSTRACT FROM AUTHOR]