Search

Preferential flow in soil has a potential impact on the maintenance of the agricultural ecosystem. The aim of this study was to quantify and evaluate the characteristics of preferential flow in drip irrigation cotton fields in Xinjiang. We applied the dye tracer method, addressed the variability in stained images, collected soil samples in the excavated soil profile, and calculated the fractal parameters in four key growth stages of cotton in 2021. According to the dyeing mode, the dyed area ratio tended to keep decreasing from the soil surface; a down movement of points which drastically dropped to zero appeared at pace with the growth of the cotton (from −10 cm to −30 cm). Statistics obtained from the staining images showed that the preferential flow degree was highest at the boll opening stage; no significant difference in non-uniformity emerged from different treatments at the same growing stage (p > 0.05). Conversely, the fractal feature parameters in the active region model probed that the preferential flow degree was developed at the flowering & bolling stage in treatments with opaque oxidation-biodegradable film mulching (B,W), and at boll opening stage with plastic film mulching (P). During the same growth period, a significant difference (p < 0.05) existed between different groups. In comparison, the fractal feature parameter was found more adequate and effective in evaluating the characteristics of preferential flow in drip irrigation cotton fields. This research will provide practical information for the local department to adjust some agronomic measures to reduce the risk of low irrigation water utilization efficiency. • Dyed area ratio had a tendency of keeping decreasing from soil surface. • Finger flow mainly appeared in the soil at the early cotton growth stage. • Macropore flow primarily developed with the maturing stages of the cotton. • Fractal feature parameter was comparatively effective to evaluate the preferential flow. [ABSTRACT FROM AUTHOR]

• Cotton yields were significantly increased by drip irrigation with plastic mulching in oasis region. • Drip irrigation with plastic mulching significantly increased soil moisture and temperature. • Drip irrigation with plastic mulching significantly increased soil CO 2 emissions. • Total CO 2 emissions in narrow rows near drip tape were highest, followed by wide rows and bare land. As the second carbon storage pool, soil is easily influenced by human activities. Mulched drip irrigation is a water-saving irrigation technique used widely in arid and semi-arid regions. However, information about the response of CO 2 exchange to mulched drip irrigation, such as the wetter and warmer soil, is limited. To identify the carbon emissions effects of mulched drip irrigation, we carried out a field experiment using drip irrigation with and without clear plastic mulching during the cotton growing seasons of 2015 and 2016. We monitored the temporal and spatial variation of soil moisture, soil temperature, cotton growth stage, biomass, lint yield, CO 2 emissions, and the relationship between soil respiration rate and soil climate. The results showed that plastic mulching drip irrigation increased soil moisture and soil temperature, especially during the early and middle growth stages of cotton. The soil respiration rate was related positively to the higher soil temperature and moisture conditions promoted by plastic film mulching, although the coefficients of determination were low (R2 were 0.480 and 0.205, corresponding p-value was both 0.000, respectively). The highest value of soil respiration was obtained within the narrow rows under the drip tape, regardless of the practice of mulching or not. The soil respiration rate under plastic mulch in the narrow and wide rows were on average 28.35 % and 22.48 % higher than non-mulched control. Meanwhile, the amount of total CO 2 emissions was significantly increased by 25.34 % and 28.90 % in these same rows, respectively (p-values were 0.006 at narrow rows and 0.010 at wide rows in the first year, and 0.000 at same rows in the second year). The differences of CO 2 emission in the bare soil was not significant between mulched plots and non-mulched control (p-values were 0.757 and 0.918 in the first and second growing seasons, respectively). In addition, plastic mulching significantly improved the biomass and yield of cotton, by 61.49 % and 12.83 % on average (p-values were 0.034 and 0.039 in 2015, 0.024 and 0.032 in 2016), respectively. The results indicate that the application of drip irrigation under plastic mulch could increase soil water content and temperature, promote cotton growth, and improve lint yield. However, it may also lead to increased CO 2 emissions, which can intensify the warming of the climate. [ABSTRACT FROM AUTHOR]

In order to harness the ample solar energy resources and minimize conflicts in drip irrigation schedules, a field experiment was conducted in Xinjiang, northwest China, during 2020 and 2021. The study examined the combined effects of two irrigation timing (daytime - DI and nighttime - NI) and four water temperatures (15, 20, 25, and 30 °C), resulting in eight treatment combinations. The analysis focused on evaluating the impacts of these factors on soil conditions, cotton phenological period, reproductive growth, and fiber quality. Results showed that elevating the irrigation water temperature had a notable impact on soil respiration throughout the different growth stages. The treatment with an irrigation water temperature of 30 °C exhibited a substantial increase in soil respiration, ranging from 17.92% to 45.95%, when compared to conventional irrigation with water temperature at 15 °C. The elevation of irrigation water temperature resulted in notable reductions in soil nitrate and ammonium nitrogen levels. Specifically, the treatment with irrigation water temperature set at 30 °C exhibited an average decrease of 21.69% and 19.27% in soil nitrate and ammonium nitrogen content, respectively, compared to the 15 °C treatment in both years. Nighttime irrigation with increased water temperatures of 20, 25, and 30 °C advanced the onset of the boll opening stage and stimulated the reproductive growth of cotton. Conversely, irrigation with regular water temperature (15 °C) decreased the number of bolls during the early boll-forming period, as well as and the peak number of squares and flowers. However, it resulted in an increased number of bolls during the late boll-forming period. Surprisingly, despite the enhancement in fiber strength and elongation due to water-warming irrigation, it unexpectedly led to a decrease in fiber length and uniformity. Moreover, higher irrigation water temperatures (25 and 30 °C) even resulted in poor levels (> 5.0) of micronaire. Nevertheless, nighttime warming irrigation improved all other fiber qualities except for uniformity. Therefore, when considering the application of water-warming irrigation in arid regions under mulched drip systems, careful selection of irrigation timing and water temperatures is necessary, taking into account the desired fiber quality. This study serves as a valuable technical reference for such irrigation practices. • Water warming promote soil respiration and nitrogen consumption. • Water temperature and irrigation timing significantly affect cotton phenology. • Water warming decreases the fiber quality of cotton. [ABSTRACT FROM AUTHOR]