Search

Rapid and efficient quality control according to the public authority regulations is mandatory to guarantee safety of the pharmaceuticals and to save resources in the pharmaceutical industry. In the case of so-called "grandfather products" like the synthetic thyroid hormone thyroxine, strict regulations enforce a detailed chemical analysis in order to characterize potentially toxic or pharmacologically relevant impurities. We report a straightforward workflow for the comprehensive impurity profiling of synthetic thyroid hormones and impurities employing ultrahigh-performance liquid chromatography (UHPLC) hyphenated to high-resolution mass spectrometry (HRMS). Five different batches of synthetic thyroxin were analyzed resulting in the detection of 71 impurities within 3 min total analysis time. Structural elucidation of the compounds was accomplished via a combination of accurate mass measurements, computer based calculations of molecular formulas, multistage high-resolution mass spectrometry (HRMS(n)), and nuclear magnetic resonance spectroscopy, which enabled the identification of 71 impurities, of which 47 have been unknown so far. Thirty of the latter were structurally elucidated, including products of deiodination, aliphatic chain oxidation, as well as dimeric compounds as new class of thyroid hormone derivatives. Limits of detection for the thyroid compounds were in the 6 ng/mL range for negative electrospray ionization mass spectrometric detection in full scan mode. Within day and day-to-day repeatabilities of retention times and peak areas were below 0.5% and 3.5% R.SD. The performance characteristics of the method in terms of robustness and information content clearly show that UHPLC-HRMS is adequate for the rapid and reliable detection, identification, and semiquantitative determination of trace levels of impurities in synthetic pharmaceuticals.

Poly(styrene-co-divinylbenzene)-based monolithic capillaries of an inner diameter of 200 mum and a length of 2-5 mm have been used to construct Ca2+-, Ag+-, and Na+-selective electrodes. The membranes consist of a solution of ionophore and ion exchanger in bis(2-ethylhexyl) sebacate or 2-nitrophenyl octyl ether, which are used as plasticizers in conventional PVC-based membranes. With capillaries of low porosity, the potentiometric responses down to 10(-8)-10(-9) M solutions do not depend on the composition of the internal solution, which indicates a strong suppression of transmembrane ion fluxes. Thus, no tedious optimization of the inner solution is required with monolith ISEs. The lower detection limits of Ag+- and Ca2+-ISEs are comparable to the best ones obtained earlier with optimized inner solutions. Additionally, a monolithic Na+-selective ISE has been obtained exhibiting a lower detection limit of 3 x 10(-8) M Na+. With monolithic capillaries of higher porosity and fused-silica GC capillaries, the transmembrane flux effects are noticeable but still significantly smaller than with conventional PVC membranes.