Search

Inorganic cesium lead halide perovskites offer a pathway towards thermally stable photovoltaics. However, moisture‐induced phase degradation restricts the application of hole transport layers (HTLs) with hygroscopic dopants. Dopant‐free HTLs fail to realize efficient photovoltaics due to severe electrical loss. Herein, we developed an electrical loss management strategy by manipulating poly(3‐hexylthiophene) with a small molecule, i.e., SMe‐TATPyr. The developed P3HT/SMe‐TATPyr HTL shows a three‐time increase of carrier mobility owing to breaking the long‐range ordering of "edge‐on" P3HT and inducing the formation of "face‐on" clusters, over 50 % decrease of the perovskite surface defect density, and a reduced voltage loss at the perovskite/HTL interface because of favorable energy level alignment. The CsPbI2Br perovskite solar cell demonstrates a record‐high efficiency of 16.93 % for dopant‐free HTL, and superior moisture and thermal stability by maintaining 96 % efficiency at low‐humidity condition (10–25 % R. H.) for 1500 hours and over 95 % efficiency after annealing at 85 °C for 1000 hours. [ABSTRACT FROM AUTHOR]

Abstract: A readily available small molecular hole‐transporting material (HTM), OMe‐TATPyr, was synthesized and tested in perovskite solar cells (PSCs). OMe‐TATPyr is a two‐dimensional π‐conjugated molecule with a pyrene core and four phenyl‐thiophene bridged triarylamine groups. It can be readily synthesized in gram scale with a low lab cost of around US$ 50 g−1. The incorporation of the phenyl‐thiophene units in OMe‐TATPyr are beneficial for not only carrier transportation through improved charge delocalization and intermolecular stacking, but also potential trap passivation via Pb–S interaction as supported by depth‐profiling XPS, photoluminescence, and electrochemical impedance analysis. As a result, an impressive best power conversion efficiency (PCE) of up to 20.6 % and an average PCE of 20.0 % with good stability has been achieved for mixed‐cation PSCs with OMe‐TATPyr with an area of 0.09 cm2. A device with an area of 1.08 cm2 based on OMe‐TATPyr demonstrates a PCE of 17.3 %. [ABSTRACT FROM AUTHOR]

A diruthenium complex with a redox-active amine bridge has been designed, synthesized, and studied by single-crystal X-ray analysis and DFT and TDDFT calculations. It shows three well-separated redox processes with exclusive near-infrared (NIR) absorbance at each redox state. The electropolymerized film of a related vinyl-functionalized complex displays multistate NIR electrochromism with low operational potential, good contrast ratio, and long retention time. Flip-flop, flip-flap-flop, and ternary memories have been realized by using the obtained film (ca. 15-20 nm thick) with three electrochemical inputs and three NIR optical outputs that each displays three levels of signal intensity. [ABSTRACT FROM AUTHOR]