Search

The determination of antibiotic potency against bacterial strains by assessment of their minimum inhibitory concentration normally uses a standardized broth microdilution assay procedure developed more than 50 years ago. However, certain antibiotics require modified assay conditions in order to observe optimal activity. For example, daptomycin requires medium supplemented with Ca 2+ , and the lipoglycopeptides dalbavancin and oritavancin require Tween 80 to be added to the growth medium to prevent the depletion of free drug via adsorption to the plastic microplate. In this report, we examine systematically the effects of several different plate types on microdilution broth MIC values for a set of antibiotics against Gram-positive and Gram-negative bacteria, both in medium alone and in medium supplemented with the commonly used additives Tween 80, lysed horse blood, and 50% human serum. We observed very significant differences in measured MICs (up to 100-fold) for some lipophilic antibiotics, such as the Gram-positive lipoglycopeptide dalbavancin and the Gram-negative lipopeptide polymyxins, and found that nonspecific binding plates can replace the need for surfactant additives. Microtiter plate types and any additives should be specified when reporting broth dilution MIC values, as results can vary dramatically for some classes of antibiotics., (Copyright © 2018 Kavanagh et al.)

Colistin adheres to a range of materials, including plastics in labware. The loss caused by adhesion influences an array of methods detrimentally, including MIC assays and in vitro time-kill experiments. The aim of this study was to characterize the extent and time course of colistin loss in different types of laboratory materials during a simulated time-kill experiment without bacteria or plasma proteins present. Three types of commonly used large test tubes, i.e., soda-lime glass, polypropylene, and polystyrene, were studied, as well as two different polystyrene microplates and low-protein-binding microtubes. The tested concentration range was 0.125 to 8 mg/liter colistin base. Exponential one-phase and two-phase functions were fitted to the data, and the adsorption of colistin to the materials was modeled with the Langmuir adsorption model. In the large test tubes, the measured start concentrations ranged between 44 and 102% of the expected values, and after 24 h, the concentrations ranged between 8 and 90%. The half-lives of colistin loss were 0.9 to 12 h. The maximum binding capacities of the three materials ranged between 0.4 and 1.1 μg/cm 2 , and the equilibrium constants ranged between 0.10 and 0.54 ml/μg. The low-protein-binding microtubes showed start concentrations between 63 and 99% and concentrations at 24 h of between 59 and 90%. In one of the microplates, the start concentrations were below the lower limit of quantification at worst. In conclusion, to minimize the effect of colistin loss due to adsorption, our study indicates that low-protein-binding polypropylene should be used when possible for measuring colistin concentrations in experimental settings, and the results discourage the use of polystyrene. Furthermore, when diluting colistin in protein-free media, the number of dilution steps should be minimized., (Copyright © 2017 American Society for Microbiology.)

Colistimethate sodium, increasingly used to treat multidrug-resistant Gram-negative infections, spontaneously hydrolyzes to form colistin A (polymyxin E1) and B (polymyxin E2/B) when mixed with water. High levels of these active breakdown products at the time of administration have been associated with nephrotoxicity and even death. In this study, reconstituted colistimethate sodium was shown to be stable (<1.0% colistin A/B formation) for up to 24 h when stored at 21, 0, -20, and -70°C.

Colistin methanesulfonate (CMS) has the potential to hydrolyze in aqueous solution to liberate colistin, its microbiologically active and more toxic parent compound. While conversion of CMS to colistin in vivo is important for bactericidal activity, liberation of colistin during storage and/or use of pharmaceutical formulations may potentiate the toxicity of CMS. To date, there has been no information available regarding the stability of CMS in pharmaceutical preparations. Two commercial CMS formulations were investigated for stability with respect to colistin content, which was measured by a specific high-performance liquid chromatography method. Coly-Mycin M Parenteral (colistimethate lyophilized powder) was stable (<0.1% of CMS present as colistin) for at least 20 weeks at 4 degrees C and 25 degrees C at 60% relative humidity. When Coly-Mycin M was reconstituted with 2 ml of water to a CMS concentration of 200 mg/ml for injection, Coly-Mycin M was stable (<0.1% colistin formed) for at least 7 days at both 4 degrees C and 25 degrees C. When further diluted to 4 mg/ml in a glucose (5%) or saline (0.9%) infusion solution as directed, CMS hydrolyzed faster at 25 degrees C (<4% colistin formed after 48 h) than at 4 degrees C (0.3% colistin formed). The second formulation, CMS Solution for Inhalation (77.5 mg/ml), was stable at 4 degrees C and 25 degrees C for at least 12 months, as determined based on colistin content (<0.1%). This study demonstrated the concentration- and temperature-dependent hydrolysis of CMS. The information provided by this study has important implications for the formulation and clinical use of CMS products.

There is a dearth of information on the pharmacodynamics of "colistin," despite its increasing use as a last line of defense for treatment of infections caused by multidrug-resistant gram-negative organisms. The antimicrobial activities of colistin and colistin methanesulfonate (CMS) were investigated by studying the time-kill kinetics of each against a type culture of Pseudomonas aeruginosa in cation-adjusted Mueller-Hinton broth. The appearance of colistin from CMS spiked at 8.0 and 32 mg/liter was measured by high-performance liquid chromatography, which generated colistin concentration-time profiles. These concentration-time profiles were subsequently mimicked in other incubations, independent of CMS, by incrementally spiking colistin. When the cultures were spiked with CMS at either concentration, there was a substantial delay in the onset of the killing effect which was not evident until the concentrations of colistin generated from the hydrolysis of CMS had reached approximately 0.5 to 1 mg/liter (i.e., approximately 0.5 to 1 times the MIC for colistin). The time course of the killing effect was similar when colistin was added incrementally to achieve the same colistin concentration-time course observed from the hydrolysis of CMS. Given that the killing kinetics of CMS can be accounted for by the appearance of colistin, CMS is an inactive prodrug of colistin with activity against P. aeruginosa. This is the first study to demonstrate the formation of colistin in microbiological media containing CMS and to demonstrate that CMS is an inactive prodrug of colistin. These findings have important implications for susceptibility testing involving "colistin," in particular, for MIC measurement and for microbiological assays and pharmacokinetic and pharmacodynamic studies.

We suggest a novel approach to enhancing antimicrobial drug action by utilizing engineered peptide conjugates. Our most potent conjugates, [fMLF]PMBN and [fMLF]PMEN, are nonapeptides derived from polymyxin B's (PMB's) cyclic moiety (Thr-Dab-cyclo[Dab-Dab-d-Phe-Leu-Dab-Dab-Thr], where Dab is 2,4-diaminobutyric acid) and polymyxin E's (PME's) cyclic moiety (Thr-Dab-cyclo[Dab-Dab-d-Leu-Leu-Dab-Dab-Thr]), respectively, attached to a linear tail comprised of formyl-Met-Leu-Phe (fMLF). The cyclic part binds to gram-negative lipopolysaccharides, rendering the bacterial outer membrane permeable to hydrophobic antibiotics. The tail confers chemotactic and opsonic activities upon the conjugates. These two activities appear to be the basis for the conjugates' antibacterial activities. The conjugates are 8 to 10 times less toxic than the parent PMB or PME antibiotics. Fourteen of 18 mice lethally challenged with erythromycin-resistant Klebsiella pneumoniae survived following intraperitoneal administration of erythromycin and [fMLF]PMBN, whereas erythromycin or the peptide conjugate alone had no effect. Moreover, the clearance of Klebsiella from blood was markedly enhanced by intravenous injection of the [fMLF]PMEN peptide conjugate compared to the clearance of the organism from the mice treated with buffer alone as a control and was similar to that achieved by the PME antibiotic. Blood clearance was also significantly enhanced by administration of PMEN either alone or in a mixture with fMLF, although the effect was less than that produced by the peptide conjugate. Since resistance to polymyxins, the parent molecules of the synthetic cyclic peptides, is rare, the emergence of bacteria resistant to the antimicrobial properties of the peptide conjugates may be precluded as well.

The stabilities of colistin and colistin methanesulfonate (CMS) in different aqueous media were studied by specific high-performance liquid chromatography (HPLC) methods. Colistin was stable in water at 4 and 37 degrees C for up to 60 days and 120 h, respectively. However, degradation was observed when colistin was stored in isotonic phosphate buffer (0.067 M, pH 7.4) and human plasma at 37 degrees C. The stability of CMS from three different sources in water was explored by strong-anion-exchange (SAX) HPLC for CMS and by measuring the concentrations of colistin formed from the hydrolysis of CMS. The peaks of CMS in SAX HPLC disappeared almost completely after 12 h at 37 degrees C, but appeared to remain intact for up to 2 days at 4 degrees C. Over the same period, there was no formation of colistin at 4 degrees C. In water, phosphate buffer, and plasma, there was rapid formation of colistin within 24 to 48 h at 37 degrees C from the three sources of CMS. The hydrolysis products were assumed to be a complex mixture of many different sulfomethyl derivatives, including colistin. The stability of a fourth source of CMS in Mueller-Hinton broth examined during 30 min at 37 degrees C revealed no formation of colistin. Along with previous microbiological studies, this suggested that different sulfomethyl CMSs possess intrinsic antibacterial activity. These results will be helpful for understanding the pharmacokinetics and pharmacodynamics of colistin and CMS in humans and animals.