Search

We report on the characterization and first laser operation of ceramic Yb:LuScO3 in a thin-disk oscillator. The optical performance achieved with a ceramic Yb:LuScO3 disk is compared to the one obtained with an existing ceramic Yb:Lu2O3 disk for reference. The characterization covers the measurement of the fluorescence spectra, the fluorescence lifetimes, and nomarsky imaging. The investigation on the laser operation covers the measurement of resonator losses, output powers, and thermal behavior during continuous-wave operation in a multimode thin-disk oscillator. An average output power of 149 W and a slope efficiency of 51.8% were achieved with the ceramic Yb:LuScO3 disk which reached a maximum surface temperature of about 150 °C. At the same temperature level, a disk made of the already established ceramic Yb:Lu2O3 delivered 957 W of output power with a slope efficiency of 75.7%. [ABSTRACT FROM AUTHOR]

We report on the direct comparison of single-crystal and ceramic Yb3+:Lu203 gain media with respect to emission spectra, fluorescence lifetime, depolarization, and laser performance in a continuous-wave thin-disk laser oscillator. The most efficient laser operation was achieved with a single-crystal disk in multimode operation with a slope efficiency of 72.1% and an average output power of 997 W. At the same temperature level, a ceramic disk delivered 861 W with a slope efficiency of 68.6%. In fundamental-mode operation, the highest average power of 360 W and highest optical efficiency of 41.3% were obtained with a ceramic disk. For the single-crystal disk, the fundamental-mode output power was limited to 113 W at an optical efficiency of 29%, potentially due to stress within the crystal. [ABSTRACT FROM AUTHOR]

In this paper, we demonstrate a SESAM mode-locked Tm:CaYLuAlO4 (a-cut) laser in the 2-μm spectral range. A birefringent filter (BF) is employed to shift the emission wavelength above 2 μm to support the stable mode locking through avoiding the structured water vapor absorption. Pulses as short as 288 fs are generated with a central wavelength of 2037 nm and an average power of 166 mW at a repetition rate of ~ 77.6 MHz. Moreover, wavelength tunable femtosecond laser with a tuning range from 2031.8 to 2081.1 nm is realized simply by rotating the birefringent filter around its surface normal. This work experimentally shows that birefringent filter is a simple and low-cost way to support the stable mode locking of Tm-bulk femtosecond lasers with an emission peak in the water vapor absorption region. [ABSTRACT FROM AUTHOR]

We report on the characterization and first laser operation of ceramic Yb:LuScO3 in a thin-disk oscillator. The optical performance achieved with a ceramic Yb:LuScO3 disk is compared to the one obtained with an existing ceramic Yb:Lu2O3 disk for reference. The characterization covers the measurement of the fluorescence spectra, the fluorescence lifetimes, and nomarsky imaging. The investigation on the laser operation covers the measurement of resonator losses, output powers, and thermal behavior during continuous-wave operation in a multimode thin-disk oscillator. An average output power of 149 W and a slope efficiency of 51.8% were achieved with the ceramic Yb:LuScO3 disk which reached a maximum surface temperature of about 150 °C. At the same temperature level, a disk made of the already established ceramic Yb:Lu2O3 delivered 957 W of output power with a slope efficiency of 75.7%. [ABSTRACT FROM AUTHOR]

We report a fully stabilized self-referenced all-solid-state-laser frequency comb based on a home-built Kerr-lens mode-locked Yb:CaYAlO4 oscillator, which delivers ultrafast pulses with a pulse duration of 54 fs and an average power of 1.5 W. Free running carrier-envelope phase offset frequency (fceo) is observed with a signal to noise ratio of 40 dB at 100 kHz resolution bandwidth, which is phase-locked to a microwave frequency synthesizer with a residual phase jitter of 370 mrad [1 Hz–1 MHz] and with a standard frequency deviation of 0.8 mHz at 1-s gate time within 3-h, corresponding to the relative frequency instability of 2.9 × 10−18 at 1-s average time. It is the lowest phase noise and the highest frequency stability of fceo obtained in a watt-level all-solid-state bulk laser frequency comb to the best of our knowledge. A 13th repetition rate is simultaneously phase-locked to the same microwave standard with a frequency instability level of 10−12 at 1 s average time. Such fully stabilized power scaling Yb: CaYAlO4 laser frequency combs have great potential for applications in broadband dual comb spectroscopy as well as high loss cases such as long-distance time and frequency transfer. [ABSTRACT FROM AUTHOR]