Search

Traditionally, in robotic surface finishing, the entire workpiece is processed at a uniform speed, predetermined by the operator, which does not account for variations in the machinability across different regions of the workpiece. This conventional approach often leads to inefficiencies, especially given the diverse geometrical characteristics of workpieces that could potentially allow for different machining speeds. Our study introduces a region-based approach, which improves surface finishing machining time by allowing variable speeds and directions tailored to each region's specific characteristics. This method leverages a task-oriented strategy integrating robot kinematics and workpiece surface geometry, subdivided by the clustering algorithm. Subsequently, methods for optimization algorithms were developed to calculate each region's optimal machining speeds and directions. The efficacy of this approach was validated through numerical results on two distinct workpieces, demonstrating significant improvements in machining times. The region-based approach yielded up to a 37% reduction in machining time compared to traditional single-direction machining. Further enhancements were achieved by optimizing the workpiece positioning, which, in our case, added up to an additional 16% improvement from the initial position. Validation processes were conducted to ensure the collaborative robot's joint velocities remained within safe operational limits while executing the region-based surface finishing strategy. [ABSTRACT FROM AUTHOR]

Workpiece placement plays a crucial role when performing complex surface machining task robotically. If the feasibility of a robotic task needs to be guaranteed, the maximum available capabilities should be higher than the joint capabilities required for task execution. This can be challenging, especially when performing a complex surface machining task with a collaborative robot, which tend to have lower motion capabilities than conventional industrial robots. Therefore, the kinematic and dynamic capabilities within the robot workspace should be evaluated prior to task execution and optimized considering specific task requirements. In order to estimate maximum directional kinematic capabilities considering the requirements of the surface machining task in a physically consistent and accurate way, the Decomposed Twist Feasibility (DTF) method will be used in this paper. Estimation of the total kinematic performance capabilities can be determined accurately and simply using this method, adjusted specifically for robotic surface machining purposes. In this study, we present the numerical results that prove the effectiveness of the DTF method in identifying the optimal placement of predetermined machining tasks within the robot's workspace that requires lowest possible joint velocities for task execution. These findings highlight the practicality of the DTF method in enhancing the feasibility of complex robotic surface machining operations. [ABSTRACT FROM AUTHOR]