Search

Accurate air quality modelling is an essential tool, both for strategic assessment (regulation development for emission controls) and for short-term forecasting (enabling warnings to be issued to protect vulnerable members of society when the pollution levels are predicted to be high). Model intercomparison studies are a valuable support to this work, being useful for identifying any issues with air quality models, and benchmarking their performance against international standards, thereby increasing confidence in their predictions. This paper presents the results of a comparison study of six chemical transport models which have been used to simulate short-term hourly to 24 hourly concentrations of fine particulate matter less than and equal to 2.5 µm in diameter (PM2.5) and ozone (O3) for Sydney, Australia. Model performance was evaluated by comparison to air quality measurements made at 16 locations for O3 and 5 locations for PM2.5, during three time periods that coincided with major atmospheric composition measurement campaigns in the region. These major campaigns included daytime measurements of PM2.5 composition, and so model performance for particulate sulfate (SO42−), nitrate (NO3−), ammonium (NH4+) and elemental carbon (EC) was evaluated at one site per modelling period. Domain-wide performance of the models for hourly O3 was good, with models meeting benchmark criteria and reproducing the observed O3 production regime (based on the O3/NOx indicator) at 80% or more of the sites. Nevertheless, model performance was worse at high (and low) O3 percentiles. Domain-wide model performance for 24 h average PM2.5 was more variable, with a general tendency for the models to under-predict PM2.5 concentrations during the summer and over-predict PM2.5 concentrations in the autumn. The modelling intercomparison exercise has led to improvements in the implementation of these models for Sydney and has increased confidence in their skill at reproducing observed atmospheric composition. [ABSTRACT FROM AUTHOR]

Volatile organic compounds (VOCs) are important precursors to the formation of ozone and fine particulate matter, the two pollutants of most concern in Sydney, Australia. Despite this importance, there are very few published measurements of ambient VOC concentrations in Australia. In this paper, we present mole fractions of several important VOCs measured during the campaign known as MUMBA (Measurements of Urban, Marine and Biogenic Air) in the Australian city of Wollongong (34°S). We particularly focus on measurements made during periods when clean marine air impacted the measurement site and on VOCs of biogenic origin. Typical unpolluted marine air mole fractions during austral summer 2012-2013 at latitude 34°S were established for CO2 (391.0 ± 0.6 ppm), CH4 (1760.1 ± 0.4 ppb), N2O (325.04 ± 0.08 ppb), CO (52.4 ± 1.7 ppb), O3 (20.5 ± 1.1 ppb), acetaldehyde (190 ± 40 ppt), acetone (260 ± 30 ppt), dimethyl sulphide (50 ± 10 ppt), benzene (20 ± 10 ppt), toluene (30 ± 20 ppt), C8H10 aromatics (23 ± 6 ppt) and C9H12 aromatics (36 ± 7 ppt). The MUMBA site was frequently influenced by VOCs of biogenic origin from a nearby strip of forested parkland to the east due to the dominant north-easterly afternoon sea breeze. VOCs from the more distant densely forested escarpment to the west also impacted the site, especially during two days of extreme heat and strong westerly winds. The relative amounts of different biogenic VOCs observed for these two biomes differed, with much larger increases of isoprene than of monoterpenes or methanol during the hot westerly winds from the escarpment than with cooler winds from the east. However, whether this was due to different vegetation types or was solely the result of the extreme temperatures is not entirely clear. We conclude that the clean marine air and biogenic signatures measured during the MUMBA campaign provide useful information about the typical abundance of several key VOCs and can be used to constrain chemical transport model simulations of the atmosphere in this poorly sampled region of the world. [ABSTRACT FROM AUTHOR]

There is increasing awareness in Australia of the health impacts of poor air quality. A common public concern raised at a number of "roadshow" events as part of the federally funded Clean Air and Urban Landscapes Hub (CAUL) project was whether or not the air quality monitoring network around Sydney was sampling air representative of typical suburban settings. In order to investigate this concern, ambient air quality measurements were made on the roof of a two-storey building in the Sydney suburb of Auburn, to simulate a typical suburban balcony site. Measurements were also taken at a busy roadside and these are discussed in a companion paper (Part 2). Measurements made at the balcony site were compared to data from three proximate regulatory air quality monitoring stations: Chullora, Liverpool and Prospect. During the 16-month measurement campaign, observations of carbon monoxide, oxides of nitrogen, ozone and particulate matter less than 2.5-µm diameter at the simulated urban balcony site were comparable to those at the closest permanent air quality stations. Despite the Auburn site experiencing 10% higher average carbon monoxide amounts than any of the permanent air quality monitoring sites, the oxides of nitrogen were within the range of the permanent sites and the pollutants of greatest concern within Sydney (PM2.5 and ozone) were both lowest at Auburn. Similar diurnal and seasonal cycles were observed between all sites, suggesting common pollutant sources and mechanisms. Therefore, it is concluded that the existing air quality network provides a good representation of typical pollution levels at the Auburn "balcony" site. [ABSTRACT FROM AUTHOR]

Biomass burnings either due to Hazards Reduction Burnings (HRBs) in late autumn and early winter or bushfires during summer periods in various part of the world (e.g., CA, USA or New South Wales, Australia) emit large amount of gaseous pollutants and aerosols. The emissions, under favourable meteorological conditions, can cause elevated atmospheric particulate concentrations in metropolitan areas and beyond. One of the pollutants of concern is black carbon (BC), which is a component of aerosol particles. BC is harmful to health and acts as a radiative forcing agent in increasing the global warming due to its light absorption properties. Remote sensing data from satellites have becoming increasingly available for research, and these provide rich datasets available on global and local scale as well as in situ aethalometer measurements allow researchers to study the emission and dispersion pattern of BC from anthropogenic and natural sources. The Department of Planning, Industry and Environment (DPIE) in New South Wales (NSW) has installed recently from 2014 to 2019 a total of nine aethalometers to measure BC in its state-wide air quality network to determine the source contribution of BC and PM2.5 (particulate Matter less than 2.5 μm in diameter) in ambient air from biomass burning and anthropogenic combustion sources. This study analysed the characteristics of spatial and temporal patterns of black carbon (BC) in New South Wales and in the Greater Metropolitan Region (GMR) of Sydney, Australia, by using these data sources as well as the trajectory HYSPLIT (Hybrid Single Particle Lagrangian Integrated Trajectory) modelling tool to determine the source of high BC concentration detected at these sites. The emission characteristics of BC in relation to PM2.5 is dependent on the emission source and is analysed using regression analysis of BC with PM2.5 time series at the receptor site for winter and summer periods. The results show that, during the winter, correlation between BC and PM2.5 is found at nearly all sites while little or no correlation is detected during the summer period. Traffic vehicle emission is the main BC emission source identified in the urban areas but was less so in the regional sites where biomass burnings/wood heating is the dominant source in winter. The BC diurnal patterns at all sites were strongly influenced by meteorology. [ABSTRACT FROM AUTHOR]

Motivated by public interest, the Clean Air and Urban Landscapes (CAUL) hub deployed instrumentation to measure air quality at a roadside location in Sydney. The main aim was to compare concentrations of fine particulate matter (PM2.5) measured along a busy road section with ambient regional urban background levels, as measured at nearby regulatory air quality stations. The study also explored spatial and temporal variations in the observed PM2.5 concentrations. The chosen area was Randwick in Sydney, because it was also the subject area for an agent-based traffic model. Over a four-day campaign in February 2017, continuous measurements of PM2.5 were made along and around the main road. In addition, a traffic counting application was used to gather data for evaluation of the agent-based traffic model. The average hourly PM2.5 concentration was 13 µg/m3, which is approximately twice the concentrations at the nearby regulatory air quality network sites measured over the same period. Roadside concentrations of PM2.5 were about 50% higher in the morning rush-hour than the afternoon rush hour, and slightly lower (reductions of <30%) 50 m away from the main road, on cross-roads. The traffic model under-estimated vehicle numbers by about 4 fold, and failed to replicate the temporal variations in traffic flow, which we assume was due to an influx of traffic from outside the study region dominating traffic patterns. Our findings suggest that those working for long hours outdoors at busy roadside locations are at greater risk of suffering detrimental health effects associated with higher levels of exposure to PM2.5. Furthermore, the worse air quality in the morning rush hour means that, where possible, joggers and cyclists should avoid busy roads around these times. [ABSTRACT FROM AUTHOR]

Airborne particulate matter (PM) is a major health risk in urban settings. Ammonia (NH3) from vehicle exhaust is an under-recognised ingredient in the formation of inorganic PM and there remains a shortage of data to properly quantify the role of NH3 from vehicles in PM formation. An Open-path Fourier transform infra-red (OP-FTIR) spectrometer measured atmospheric NH3, carbon monoxide (CO) and carbon dioxide (CO2) at high temporal resolution (5 min) in Western Sydney over 11 months. The oxides of nitrogen (NO2 and NO; NOx) and sulphur dioxide (SO2) were measured at an adjacent air quality monitoring station. NH3 levels were maxima in the morning and evening coincident with peak traffic. During peak traffic NH3:CO ratio ranged from 0.018 to 0.022 ppbv:ppbv. Results were compared with the Greater Metropolitan Region 2008 (GMR2008) emissions inventory. Measured NH3:CO was higher during peak traffic times than the GMR2008 emissions estimates, indicating an underestimation of vehicle NH3 emissions in the inventory. Measurements also indicated the urban atmosphere was NH3 rich for the formation of ammonium sulphate ((NH4)2SO4) particulate was SO2 limited while the formation of ammonium nitrate (NH4NO3) was NH3 limited. Any reduction in NOx emissions with improved catalytic converter efficiency will be accompanied by an increase in NH3 production and potentially with an increase in NH4NO3 particulate. [ABSTRACT FROM AUTHOR]