Search

We examined the impact of dimethylsulfide (DMS) emissions on sulfate concentrations over the continental U.S. by using the Community Multiscale Air Quality (CMAQ) model version 5.4 and performing annual simulations without and with DMS emissions for 2018. DMS emissions enhance sulfate not only over seawater but also over land, although to a lesser extent. On an annual basis, the inclusion of DMS emissions increase sulfate concentrations by 36% over seawater and 9% over land. The largest impacts over land occur in California, Oregon, Washington, and Florida, where the annual mean sulfate concentrations increase by ~25%. The increase in sulfate causes a decrease in nitrate concentration due to limited ammonia concentration, especially over seawater, and an increase in ammonium concentration with a net effect of increased inorganic particles. The largest sulfate enhancement occurs near the surface (over seawater), and the enhancement decreases with altitude, diminishing to 10–20% at an altitude of ~5 km. Seasonally, the largest enhancement in sulfate over seawater occurs in summer, and the lowest in winter. In contrast, the largest enhancements over land occur in spring and fall due to higher wind speeds that can transport more sulfate from seawater into land. [ABSTRACT FROM AUTHOR]

Comparison of lightning flash data from the National Lightning Detection Network (NLDN) and from the World Wide Lightning Location Network (WWLLN) over the contiguous United States (CONUS) for the 2016–2018 period reveals temporally and spatially varying flash rates that would influence lightning NOx (LNOx) production due to known detection efficiency differences especially during summer months over land (versus over ocean). However, the lightning flash density differences between the two networks show persistent seasonal patterns over geographical regions (e.g., land versus ocean). Since the NLDN data are considered to have higher accuracy (lightning detection with >95% efficiency), we developed scaling factors for the WWLLN flash data based on the ratios of WWLLN to NLDN flash data over time (months of year) and space. In this study, sensitivity simulations using the Community Multiscale Air Quality (CMAQ) model are performed utilizing the original data sets (both NLDN and WWLLN) and the scaled WWLLN flash data for LNOx production over the CONUS. The model performance of using the different lightning flash datasets for ambient O3 and NOx mixing ratios that are directly impacted by LNOx emissions and the wet and dry deposition of oxidized nitrogen species that are indirectly impacted by LNOx emissions is assessed based on comparisons with ground-based observations, vertical profile measurements, and satellite products. During summer months, the original WWLLN data produced less LNOx emissions (due to its lower lightning detection efficiency) compared to the NLDN data, which resulted in less improvement in model performance than the simulation using NLDN data as compared to the simulation without any LNOx emissions. However, the scaled WWLLN data produced LNOx estimates and model performance comparable with the NLDN data, suggesting that scaled WWLLN may be used as a substitute for the NLDN data to provide LNOx estimates in air quality models when the NLDN data are not available (e.g., due to prohibitive cost or lack of spatial coverage). [ABSTRACT FROM AUTHOR]