Search

The flow field induced by multirotor drones is of high interest for atmospheric research, as it locally influences the atmosphere and therefore may have an impact on the sensors installed for atmospheric measurements. Further, on-board vibrations can cause significant interference with the measurement equipment. To investigate the near flow field, an approach combining measurements of pressure and temperature distribution in-flight and in a laboratory setup together with numerical simulations was applied. Existing high-frequency measurement equipment was piggybacked during the initial flight tests with a newly developed 25 kg quadcopter system in a low-cost early-stage-error approach to obtain initial data and experience. During the flights, high resolution sensors for measuring pressure, temperature, acceleration, and deformation were applied with different setups at different locations below one of the rotor planes, respectively, at one rotor arm, to determine the multicopter’s influence on pressure and temperature measurements, to investigate rotor arm deformations, and to obtain data to compare with numerical simulations of this rotor setup. An external Schlieren-type measurement technique was tested to visualise the rotor vortices. The applied measurement techniques proved to be suitable for acquiring the state of the rotor-induced flow, but with some limitations. The comparison of measurements and simulations showed basic agreement and allowed for the identification of necessary adaptations for subsequent studies. The interaction of the rotor wakes with the rotor arms could be identified as the main source of the measured structural vibrations. The need for necessary improvements in the measurement setup, flight operation, and simulation setup is presented in detail.

Air quality measurements usually consist of ground-based instrumentation at fixed locations. However, vertical profiles of pollutants are of interest for understanding processes, distribution, dilution and concentration. Therefore, a multicopter system has been developed to investigate the vertical distribution of the concentration of aerosol particles, black carbon, ozone, nitrogen oxides (NOx) and carbon monoxide and the meteorological parameters of temperature and humidity. This article presents the requirements by different users, the setup of the quadrocopter system, the instrumentation and the results of first applications. The vertical distribution of particulate matter next to a highway was strongly related to atmospheric stratification, with different concentrations below and above the temperature inversion present in the morning. After the qualification phase described in this article, two identically equipped multicopters will be used upwind and downwind of line or diffuse sources such as highways or urban areas to quantify the influence of their emissions on the local air quality.

Wind shear at low altitudes represents a potential hazard to landing aircraft. Based on two wind lidar data sets of one year, the occurrence of low-level jets (LLJs), the vertical wind shear and the rotation of the wind direction were analysed. The lidar system was located at the sites of Braunschweig in the North German Plain, Germany, and Clausthal-Zellerfeld in the low mountain range Harz, Germany. The observed wind shear gradients between the altitude of 40 m and the altitude of the maximum wind speed was in the range of −0.23 s−1 to +0.20 s−1. The rotation of the wind direction with altitude occurred both in clockwise and anticlockwise direction. The ratio of clockwise versus anticlockwise occurrence of directional shear was 4:1 for Braunschweig and 3:1 for Clausthal-Zellerfeld. The observed wind shear gradients were compared to values for hazard potential of different levels for a typical aircraft. Although the LLJ was not hazardous for manned aircraft in any observed case, the awareness of LLJ helps to reduce the pilot’s workload and possible pilot-introduced oscillations caused as a result of the wind shear and aircraft characteristics. In contrast to manned aviation, the value of changes in wind speed and direction during LLJ conditions can cause significant risks for unmanned aerial system operations with less than 25 kg of take-off weight. This is a result of the lower airspeed-wind-speed ratio and the flight control and flight planning.

Unmanned aerial systems (UAS) fill a gap in high-resolution observations of meteorological parameters on small scales in the atmospheric boundary layer (ABL). Especially in the remote polar areas, there is a strong need for such detailed observations with different research foci. In this study, three systems are presented which have been adapted to the particular needs for operating in harsh polar environments: The fixed-wing aircraft M 2 AV with a mass of 6 kg, the quadrocopter ALICE with a mass of 19 kg, and the fixed-wing aircraft ALADINA with a mass of almost 25 kg. For all three systems, their particular modifications for polar operations are documented, in particular the insulation and heating requirements for low temperatures. Each system has completed meteorological observations under challenging conditions, including take-off and landing on the ice surface, low temperatures (down to −28 ∘ C), icing, and, for the quadrocopter, under the impact of the rotor downwash. The influence on the measured parameters is addressed here in the form of numerical simulations and spectral data analysis. Furthermore, results from several case studies are discussed: With the M 2 AV, low-level flights above leads in Antarctic sea ice were performed to study the impact of areas of open water within ice surfaces on the ABL, and a comparison with simulations was performed. ALICE was used to study the small-scale structure and short-term variability of the ABL during a cruise of RV Polarstern to the 79 ∘ N glacier in Greenland. With ALADINA, aerosol measurements of different size classes were performed in Ny-Ålesund, Svalbard, in highly complex terrain. In particular, very small, freshly formed particles are difficult to monitor and require the active control of temperature inside the instruments. The main aim of the article is to demonstrate the potential of UAS for ABL studies in polar environments, and to provide practical advice for future research activities with similar systems.

European groundwater reservoirs are frequently subject to reactive nitrogen pollution (Nr) owing to the intensive use of nitrogen (N) fertilizer and animal manure in agriculture. Besides its risk on human health, groundwater Nr loading also affects the carbon (C) and N cycle of associated ecosystems. For a temperate grassland in Germany, the long-term (12 years) annual average exports of Nr in form of harvest exceeded Nr inputs via fertilization and deposition by more than 50 kgN ha−1. We hypothesize that the resulting deficit in the N budget of the plant-soil system could be closed by Nr input via the groundwater. To test this hypothesis, the ecosystem model LandscapeDNDC was used to simulate the C and N cycle of the respective grassland under different model setups, i.e., with and without additional Nr inputs via groundwater transport. Simulated plant nitrate uptake compensated the measured N deficit for 2 of 3 plots and lead to substantial improvements regarding the match between simulated and observed plant biomass and CO2 emission. This suggests that the C and N cycle of the investigated grassland were influenced by Nr inputs via groundwater transport. We also found that inputs of nitrate-rich groundwater increased the modelled nitrous oxide (N2O) emissions, while soil water content was not affected.

The authors would like to correct the published article [1] concerning acknowledgments as follows[...]

The unmanned research aircraft ALADINA (Application of Light-weight Aircraft for Detecting in situ Aerosols) has been established as an important tool for boundary layer research. For simplified integration of additional sensor payload, a flexible and reliable data acquisition system was developed at the Institute of Flight Guidance, Technische Universität (TU) Braunschweig. The instrumentation consists of sensors for temperature, humidity, three-dimensional wind vector, position, black carbon, irradiance and atmospheric particles in the diameter range of ultra-fine particles up to the accumulation mode. The modular concept allows for straightforward integration and exchange of sensors. So far, more than 200 measurement flights have been performed with the robustly-engineered system ALADINA at different locations. The obtained datasets are unique in the field of atmospheric boundary layer research. In this study, a new data processing method for deriving parameters with fast resolution and to provide reliable accuracies is presented. Based on tests in the field and in the laboratory, the limitations and verifiability of integrated sensors are discussed.