Search

Abstract: This paper uses the 2006 IPCC Guidelines and latest country specific emission factors to estimate Indian methane emissions at sectoral and district level for the years 1990, 1995, 2005 and 2008. The estimates show that while methane emissions have increased steadily over past two decades, their share in India’s aggregate GHG emissions has declined from 31% in 1985 to 27% in 2008 mainly due to relatively higher growth CO2 emissions from the fossil fuels. The estimates for the year 2008 show that: i) agriculture sector, which employed two-thirds of India’s population and contributed 17% of GDP, accounted for 23% of India’s GHG emissions ii) 83% of country’s methane emissions are contributed by enteric fermentation, manure use and rice production, and iii) methane emissions from urban solid waste are steadily rising over the past two decades; their share in aggregate methane emissions has reached 8%. Resting on the disaggregated emissions estimates, the paper argues for using geographical and sectoral flexibilities to develop a roadmap for mitigation of methane emissions for India. [Copyright &y& Elsevier]

India has more than 100,000 brick kilns producing around 250 billion bricks annually. Indian brick industry is often a small scale industry and third largest consumer of coal in the country. With the growing demand for building materials and characterised by lack of pollution control measures the brick industry has a potential to cause adverse effects on the environment. This paper presents assessment of five brick making technologies based on the measurements carried out at seventeen individual brick kilns. Emissions of PM, SO 2 , CO and CO 2 were measured and these emissions were used to estimate the emission factors for comparing the emissions across different fuel or operating conditions. Estimated emission from brick kilns in South Asia are about 0.94 million tonnes of PM; 3.9 million tonnes of CO and 127 million tonnes of CO 2 per year. Among various technologies that are widely used in India, Zig zag and vertical shaft brick kilns showed better performance in terms of emissions over the traditional fixed chimney Bull's trench kilns. This suggests that the replacement of traditional technologies with Zig zag, vertical shaft brick kilns or other cleaner kiln technologies will contribute towards improvements in the environmental performance of brick kiln industry in the country. Zig zag kilns appear to be the logical replacement because of low capital investment, easy integration with the existing production process, and the possibility of retrofitting fixed chimney Bull's trench kilns into Zig zag firing. [ABSTRACT FROM AUTHOR]

The global burden of disease study estimated 695,000 premature deaths in 2010 due to continued exposure to outdoor particulate matter and ozone pollution for India. By 2030, the expected growth in many of the sectors (industries, residential, transportation, power generation, and construction) will result in an increase in pollution related health impacts for most cities. The available information on urban air pollution, their sources, and the potential of various interventions to control pollution, should help us propose a cleaner path to 2030. In this paper, we present an overview of the emission sources and control options for better air quality in Indian cities, with a particular focus on interventions like urban public transportation facilities; travel demand management; emission regulations for power plants; clean technology for brick kilns; management of road dust; and waste management to control open waste burning. Also included is a broader discussion on key institutional measures, like public awareness and scientific studies, necessary for building an effective air quality management plan in Indian cities. [ABSTRACT FROM AUTHOR]

This paper examines the role of meteorology in linking near surface emissions of particulate matter and associated ambient concentrations in urban areas. The examination is conducted with two models: a steady state model based on urban dispersion models developed earlier, and an unsteady state model that accounts for time varying meteorological and emission inputs. After conducting sensitivity studies with the models, they are applied in Pune, India to (a) check consistency between estimates of surface emissions of particulate matter (with aerodynamic diameters of less than m, referred to as PM and observed ambient concentrations and (b) identify the variables that govern air quality. Results from the modeling exercise indicate that (1) nighttime meteorology governs both hourly as well as 24h averaged concentrations and (2) because the wind speeds in urban areas are typically low, concentration estimates from the steady state model differ substantially from those of the unsteady state model during the nighttime hours both in magnitude and in timing of the peaks; however, the difference between the 24h averaged concentrations from the two models is less than 5% for the cases considered here. Because our understanding of nighttime meteorology in urban areas is limited, there is a need for experimental programs to relate the diurnal variation of concentrations with associated meteorology, especially during the night. [Copyright &y& Elsevier]

Abstract: This paper provides the trends of greenhouse gas (GHG) and local air pollutant emissions of India for 1985–2005. The GHGs covered are six Kyoto gases, namely carbon dioxide (CO2), methane (CH4), nitrous oxide (N2O), perfluorocarbons (PFCs), hydrofluorocarbons (HFCs) and sulfur hexafluoride (SF6). The local air pollutants are sulfur dioxide (SO2), nitrogen oxides (NO X ), carbon monoxide (CO) and total suspended particulates (TSP). These estimates incorporate some of the most recent scientific assessments for India. The multigas emissions have varied sectoral and fuel-based dominance, as well as regional distribution patterns. Coal consumption in power sector dominates CO2 and SO2 emissions, while power and road transport equally contribute to NO X emissions. Rice cultivation and livestock-related emissions from the agriculture sector dominate CH4 emissions, while synthetic fertilizer use in the same sector is the major source of N2O emissions. PFC emissions are dominated by C2F6 and CF4 emissions from aluminum production. The majority of HFC emissions are contributed by HFC-23, a by-product during the production of HCFC-22 that is widely used in refrigeration industry. CO emissions have dominance from biomass burning. Particulate emissions are dominated by biomass burning (residential sector), road transport and coal combustion in large plants. These varied emission patterns provide interesting policy links and disjoints, such as—which and where mitigation flexibility for the Kyoto gases, exploring co-benefits of CO2 and SO2 mitigation, and technology and development pathway dependence of emissions. The present inventory assessment is a pointer to the future emission pathways for India wherein local air pollutant and GHG emissions, although connected, may not move in synchronization and therefore would require alignment through well crafted development and environment strategies. [Copyright &y& Elsevier]

Abstract: Chemical simulations in most of the atmospheric chemistry models require surface emissions in a specific form (gridded), which are often not available. Simple interpolation of broader level emissions to obtain gridded data may lead to erroneous results. An attempt has been made in this paper to develop a geographical information system (GIS) based methodology for distributing the emissions from a broader level inventory to finely gridded emission values, considering local micro-level details and activity data. Given the importance of Carbon Monoxide emissions in ozone pollution chemistry over India, an emission inventory for CO from various sources for India has been used to demonstrate the GIS-based gridding methodology. The total CO emissions over India for 2001, which are estimated to be around 69.0Tgyear−1, have been downscaled source-wise (distinguishing between rural and urban bio-fuel, vehicular traffic, coal and biomass burning) from state-level (28 points) to district level (∼500 points) before mapping through a GIS utility and finally gridded to a 1°×1° resolution with a data loss of only about 13%. The final results provide detailed information with emission “hot spots” and the relative contribution of various sources. This article focuses on usage of the GIS based statistical methodology for gridding the inventory and the results obtained thereof are discussed. [Copyright &y& Elsevier]