Search

Abstract: The authors tested a 409 kW forager turned into an industrial chipper through a special conversion kit. Conversion was temporary, and the forager could be returned to its original occupation with one day of work. The converted forager proved as effective as a dedicated chipper of the same power. Net chipping productivity varied between 25 and 33 green t h−1. Productivity was highest with poplar tops and lowest with pine tops. Fuel consumption ranged from 1.6 to 1.8 l green t−1. Fuel consumption did not change with tree species, but increased significantly with knife wear. Temporary conversion allowed a better depreciation of the invested capital and resulted in a 25% reduction of unit chipping cost. The converted forager proved an ideal solution wherever the production of wood chips was a complementary business within the scope of a larger agricultural economy. In technical terms, this machine offered the combined advantages of road-capability and good off-road mobility, allowing low-cost independent relocation and effective in-field chipping. [Copyright &y& Elsevier]

Abstract: A commercial drum chipper was fed alternately and piecewise with poplar stems and poplar tops, in order to determine the effect of piece size and tree part on machine performance. Chipping stems required most of the available power (231 kW) delivered by the tractor, whereas chipping tops took about half that much. However, productivity was twice as high with stems, compared to tops (i.e. 25 and 11 t h−1 of oven dry wood, respectively). As a consequence, specific fuel consumption per unit product was 15% lower with stems, compared to tops – i.e. 0.61 and 0.72 L m−3, respectively. Mean feeding speed was 0.37 m s−1 for stems and 0.41 m s−1 for tops, but the difference was not significant (p = 0.1677). Productivity and fuel consumption were strongly related to piece size, but tree part had its own additional effect, independent from size and possibly related to form. When chipping tops it is advisable to feed more pieces at a time, in order to partly compensate for the effect of piece size. Operators expecting to chip primarily small-size materials may acquire special chipper versions with wider drums and additional side rollers, for smoother mass feeding. [Copyright &y& Elsevier]