Search

Background The purpose of this study was to evaluate the feasibility of utilizing an in-vitro, closed loop hemodialysis system as a method to assess drug clearance. Secondarily, this study tested the influence of variables (blood flow rate, dialysate flow rate, and type of filter) in the hemodialysis procedure on the clearance of vancomycin and gentamicin. Methods An in-vitro, closed loop hemodialysis system was constructed. The vancomycin (30 mg/L) and gentamicin (25 mg/L) were added to a simulated blood system (SBS). Four conditions (C1-C4) were tested by defining the filter (Polyflux 170H or F180) and the blood and dialysate flow rates (BFR and DFR). All hemodialysis sessions were 3 hours in length and each condition was completed in duplicate. Dialysate effluent was collected in a 50 gallon polyethylene drum. Samples were collected (in duplicate) from the SBS and the dialysate effluent at baseline and at the end of the hemodialysis session. Samples were analyzed for vancomycin and gentamicin with an ultrahigh performance liquid chromatography/tandem mass spectrometry method. Results A total of eight 3-hour hemodialysis sessions were conducted. For all tested conditions (C1-C4), vancomycin was undetectable in the SBS at the end of dialysis. However, total vancomycin recovery in the dialysis effluent was 85±18%, suggesting that up to 15% may have adsorbed to the dialysis filter or tubing. Gentamicin clearance from SBS was >98% in all tested conditions. Average gentamicin recovery in the dialysate effluent was 99±15%. Conclusion Both vancomycin and gentamicin were readily removed by high-flux hemodialysis under all conditions studied. No significant differences in drug clearance were observed between conditions used in this in vitro study. The clinical implications of changing these hemodialysis parameters are unknown.

Background Intravenous iron is typically administered during the hemodialysis (HD) procedure. HD patients may be prescribed high-flux (HF) or high-efficiency (HE) dialysis membranes. The extent of iron sucrose and iron dextran removal by HD using HF or HE membranes and by ultrafiltration rate (UFR) is unknown. Methods Two in vitro HD systems were designed and constructed to determine the dialyzabiltiy of iron from a simulated blood system (SBS) containing 100 mg iron sucrose or iron dextran (system A) or 1000 mg iron sucrose (system B). Both in vitro systems utilized a 6-L closed-loop SBS system that was subject to 4 different HD conditions conducted over 4 hours: HE membrane + 0 ml/hr UFR; HE membrane + 500 ml/hr UFR; HF membrane + 0 ml/hr UFR; HF membrane + 500 ml/hr UFR. Blood flow and dialysate flow rates were 500 ml/min and 800 ml/min, respectively. The dialysate compartment was a 192-L open system for system A and a 6-L closed-loop system for system B. Samples from the SBS and dialysate compartments were taken at various time points and iron elimination rate and HD clearance was determined. Iron removal from the SBS > 15% was considered clinically significant. Results The greatest percentage removal from the SBS was 13.5% and -0.03% utilizing system A and B, respectively. Iron sucrose and iron dextran dialysate concentration was below the lower limits of assay (< 2 ppm) for system A. Dialysate recovery of iron was negligible: 0 – 5.4 mg system A and 5.47 – 23.59 mg for system B. Dialyzer type or UFR did not affect iron removal. Conclusion HF or HE dialysis membranes do not remove clinically significant amounts of iron sucrose or dextran formulations over a 4-hour HD session. This effect remained constant even controlling for UFR up to 500 ml/hour. Therefore, iron sucrose and iron dextran are not dialyzed by HE or HF dialysis membranes irrespective of UFR.