Search

The morphology, sedimentology and architecture of an end moraine formed by a ∼9 km surge of Brúarjökull in 1963–64 are described and related to ice-marginal conditions at surge termination. Field observations and accurate mapping using digital elevation models and high-resolution aerial photographs recorded at surge termination and after the surge show that commonly the surge end moraine was positioned underneath the glacier snout by the termination of the surge. Ground-penetrating radar profiles and sedimentological data reveal 4–5 m thick deformed sediments consisting of a top layer of till overlying gravel and fine-grained sediments, and structural geological investigations show that the end moraine is dominated by thrust sheets. A sequential model explaining the formation of submarginal end moraines is proposed. The hydraulic conductivity of the bed had a major influence on the subglacial drainage efficiency and associated porewater pressure at the end of the surge, thereby affecting the rates of subglacial deformation. High porewater pressure in the till decreased its shear strength and raised its strain rate, while low porewater pressure in the underlying gravel had the opposite effect, such that the gravel deformed more slowly than the till. The principal velocity component was therefore located within the till, allowing the glacier to override the gravel thrust sheets that constitute the end moraine. The model suggests that the processes responsible for the formation of submarginal end moraines are different from those operating during the formation of proglacial end moraines. [ABSTRACT FROM AUTHOR]

An extensive dead-ice area has developed at the stagnant snout of the Holmströmbreen glacier, Svalbard, following its last advance during the Little Ice Age (LIA). The most common landform is ice-cored slopes hosting sediment gravity flows. Dead-ice melting is described and quantified through field studies and analyses of high-resolution, multi-temporal aerial photographs and QuickBird 2 satellite imagery. Field measurements of backwasting of ice-cored slopes indicate melting rates of 9.2 cm/day. Downwasting rates reveal a dead-ice surface lowering of 0.9 m/yr from 1984 to 2004. The volume of melted dead-ice in the marginal zone since the LIA is estimated at 2.72 km3. Most prominently, dead-ice melting causes the growth of an ice-walled lake with an area increasing near-exponentially over the last 40 years. Despite the high-Arctic setting, dead-ice melting progresses with similar rates as in humid sub-polar climates, stressing that melt rates are governed by processes and topography rather than climate. We suggest that the permafrost and lack of glacier karst prevent meltwater percolation, thus maintaining a liquefied debris-cover where new dead-ice is continuously exposed to melting. As long as backwasting and mass movement processes prevent build-up of an insulating debris-cover, the de-icing continues despite the continuous permafrost. [ABSTRACT FROM AUTHOR]

Mature dead-ice has been overridden repeatedly by the Brúarjökull glacier, and multiple generations of ice-cored landforms occur, with ice cores originating at least from glacier surges in 1963-1964, 1890 and 1810. Ice-cores are located on the proximal slopes of end moraines and in the valleys, as ice-cored outwash and eskers, ice-cored drumlins and ice-cored moraine patches. This dictates that the sediments and internal architecture might not always match their end-products as de-icing progresses. Analysis of multi-temporal aerial photographs integrated with annual field measurements showed that the time required for a total de-icing in the forefield exceeds the duration of the quiescent phases between the surges, even in the current climate at the limit of permafrost. Quantifying melting progression suggests that complete de-icing of ice-cored landforms is not likely to occur. The mean de-icing rate is c. 9.8 cm/yr in 1890 ice-cored moraines, and c. 17.7 cm/yr in 1963-1964 ice-cored moraines. Backwasting of ice-cored slopes (c. 30 cm/yr) is the fastest melt process. Long-term downwasting rates derived from multi-temporal digital elevation models provide a superior insight into the impact of multiple glacier surges on the formation of dead-ice moraines in front of Brúarjökull. [ABSTRACT FROM AUTHOR]