Search

The ambient PAHs levels in the downtown area of a traditional small city were analyzed for winter and summer seasons. A total of 16 PAHs in gaseous and particulate phase were quantified. The average gaseous PAHs were 2,189 ± 1,194 and 623.8 ± 545.1 ng/m(3) in winter and summer seasons, respectively. For the PAHs in particulate phase, they were 40.32 ± 12.15 and 11.99 ± 5.63 ng/m(3) in winter and summer seasons, respectively. These values were comparable to those reported for large cities or even higher. The estimated BaPeq was 12.32 ± 6.34 ng/m(3). As low-molecular-weight PAHs primarily existed in gaseous phase, high-molecular-weight PAHs in particulate phase became a significant fraction of total particulate phase PAHs. Particulate phase PAHs was significantly inversely associated with the ambient temperature for each individual PAHs species. However, this relationship did not exist for high-molecular-weight PAHs in gaseous phase. The results indicated the photo-degradation of high-molecular-weight PAHs should warrant a further thoughtfully investigation.

Release of polycyclic aromatic hydrocarbons (PAHs) in particles of various sizes from smoldering incenses was determined. Among the three types of incense investigated, yielding the total PAH emission rate and factor ranges for PM0.25 were 2,139.7-6,595.6 ng/h and 1,762.2-8,094.9 ng/g, respectively. The PM0.25/PM2.5 ratio of total PAH emission factors and rates from smoldering three incenses was greater than 0.92. This study shows that total particle PAH emission rates and factors were mainly <0.25 μm. Furthermore, the total toxic equivalency emission rates and factors of PAHs for PM0.25 were 241.3-469.7 and 198.8-576.2 ng/g from the three smoldering incenses. The benzo[a]pyrene accounted for 65.2%-68.0% of the total toxic equivalency emission factor of PM2.5 for the three incenses. Experimental results clearly indicate that the PAH emission rates and factors were influenced significantly by incense composition, including carbon and hydrogen content. The study concludes that smoldering incense with low atomic hydrogen/carbon ratios minimized the production of total polycyclic aromatic hydrocarbons of both PM2.5 and PM0.25.

This work studied the feasibility of using a solid phase microextraction (SPME) fiber for sampling and analysis of gaseous formaldehyde as well as particulate-bound formaldehyde from burning Chinese incense. The SPME fiber with PDMS/DVB coating were partially coated with o-(2,3,4,5,6-pentafluorobenzyl)-hydroxylamine hydrochloride (PFBHA), and used for sampling formaldehyde. The sampling rate for formaldehyde and its dependence on temperature, relative humidity and sampling time were observed. The same PFBHA treated fibers were, in parallel, exposed to incense burning smoke with pre-filtration and without pre- filtration for 0.5-1 min. The NIOSH method 2541 using an XAD-2 tube at a flow rate of 0.1 Lpm was also applied for sampling simultaneously. The results demonstrate that commercially available PDMS/DVB fibers partially coated with PFBHA are capable of sampling the gas phase of formaldehyde as well as particulate-bound formaldehyde. The determined level of formaldehyde was close to the result obtained by the NIOSH method 2541. However, a reduction of the fiber's formaldehyde loading capacity in the aerosol sampling in comparison with gas sampling was noticed. This indicates that the particulate characteristics, and their bound chemicals other than formaldehyde may influence the maximum loading capacity of formaldehyde, and some characteristic particulates in high concentrations may even deteriorate the fiber coating.