Search

This study describes a conservative approach to surgical management of root canal perforation in maxillary lateral incisors. A patient was referred for retreatment of a maxillary lateral incisor. Her chief complaint was discomfort in the buccal mucosa. Periapical radiography showed radiopaque material consistent with sealing material inside the root canal. A CBCT scan was acquired and revealed a gutta-percha cone outside the root canal, from the middle third to beyond the root apex. The imaging examination showed that the pulp cavity had not been affected. Thus, we took the clinical alternative of surgically managing the perforation by sealing with MTA, thereby avoiding endodontic treatment, and followed up with only clinical and radiographic control. At the two-year follow-up, after the surgical procedure to remove the extruded filling material, we observed bone tissue formation and positive response to pulp tests, without any clinical signs or symptoms. Root perforation is considered an unpleasant error in an operative procedure. Once a perforation is properly diagnosed, located, and sealed with biomaterial, a favorable prognosis is often achieved. MTA offered good sealing of the perforation, with promising results. Decision-making using the CBCT scan enabled us to adopt a conservative approach and favored more reliable treatment predictability.

Maxillary lateral incisor agenesis is the most prevalent developmental dental anomaly. The management of missing lateral incisor was either closure using canine as substitution or creation of space orthodontically for prosthetic replacement. A careful diagnosis and treatment plan are deemed essential to address the patient’s needs as the spacing is present in the esthetic region. Such problem is very challenging for orthodontists, prosthodontists, and general practitioners. This case report describes the orthodontic management of a 22-year-old adult female patient with missing upper left lateral incisor tooth and upper anterior spacing by closing the space with canine lateralization and reshaping to simulate it with the lateral incisor. However, some modifications in the treatment mechanics are crucial to achieve the optimal esthetic and to improve the occlusion. Space closure with canine lateralization option seems less invasive, treatment can be completed relatively in a short period of time, and its adaptation with the facial changes throughout life without having artificial prosthesis provided other factors favoring for this option.

Introduction. The radicular groove is a developmental groove which is usually found on the palatal or lateral aspects of the maxillary incisor teeth. The present case is a maxillary lateral incisor with a small second root and a deep radicular groove. The developmental groove caused a combined periodontal-endodontic lesion. Methods. Case was managed using a combined treatment procedure involving nonsurgical root canal therapy and surgical periodontal treatment. After completion of root canal treatment, guided tissue regeneration (GTR) was carried out using decalcified freeze dried bone allograft (DFDBA) and a bioabsorbable collagenous membrane. Tooth also was splinted for two months. Results. After 12 months the tooth was asymptomatic. The periapical radiolucency disappeared and probing depth did not exceed 3 mm. Conclusion. Combined treatment procedure involving nonsurgical root canal therapy and surgical periodontal regenerative treatment can be a predictable technique in treating combined endodontic-periodontal lesions caused by radicular groove.

Adenomatoid odontogenic tumor (AOT), a benign (hamartomatous) lesion of odontogenic origin, is an uncommon tumor which affects mainly females in the second decade. This lesion is most commonly associated with an impacted maxillary canine. This paper reported a case of AOT, in a 16-year-old female, associated with an impacted maxillary left lateral incisor. The evolution of this tumor was followed over 36 months and 24 months after excision.

Dens invaginatus (DI) is a malformation of teeth probably resulting from an infolding of the dental papilla during tooth development. DI is classified as type I, II, and III by Oehlers depending on the severity of malformation. The maxillary lateral incisor is the most commonly affected tooth. Structural defects do exist in the depth of the invagination pits, and as a consequence, the early development of caries and the subsequent necrosis of the dental pulp, as well as abscess and cyst formation are clinical implications associated with DI. Occasionally, we can see more than one developmental anomaly occurring in a single tooth. In such cases it becomes important to identify the anomalies and initiate a proper treatment plan for good prognosis. In this paper, an unusual case of DI which clinically presented as a huge talons cusp affecting a mandibular lateral incisor tooth is described. This case report illustrates grinding of the talons cusp followed by nonsurgical endodontic management of dens invaginatus type II with an immature apex and periapical lesions, in which Mineral Trioxide Aggregate (MTA) shows a complete periapical healing with bone formation at the site of the lesions.

Dens invaginatus is a developmental anomaly that results in an enamel-lined cavity intruding into the crown or root before the mineralization phase. It typically affects permanent maxillary lateral incisors, central incisors, and premolars. This paper describes the root canal treatment of Oehlers’ type II dens invaginatus in maxillary left lateral incisors. A 16-year-old boy presented to the Faculty of Dentistry, University of Kocaeli, to receive his dental treatments. During the caries removal, the pulp was exposed then anendodontic treatment was initiated. Two canals, one of which represented the invagination, were instrumented, irrigated, and then obturated with a lateral condensation technique.

Dens Invaginatus is a dental malformation that poses diagnostic difficulties in the clinical context. This anomaly may increase the risk of pulp disease and can potentially complicate endodontic procedure due to the aberrant root canal anatomy. Compared to conventional radiographs, three-dimensional images obtained with Cone Beam Computed Tomography (CBCT) are invaluable in the diagnosis of the extent of this anomaly and in the appropriate treatment planning. Oehler’s classification (1957) for Dens Invaginatus (DI) into three types depending on the depth of the invagination has been used for treatment planning. Of the three types Type III DI is characterized by infolding of the enamel into the tooth up to the root apex and is considered as the most severe variant of DI and hence the most challenging to treat endodontically, due to the morphological complexities. This report describes a case of Oehler’s Type III DI in a necrotic permanent maxillary lateral incisor in which CBCT images played a key role in diagnosis and treatment planning. The case was managed successfully by a combination of nonsurgical and surgical endodontic therapy with orthograde and retrograde thermoplastic gutta percha obturation.

The purpose of this case report was to present the multidisciplinary management of a subgingival crown-root fracture of a patient undergoing apexification treatment. A 12-year-old male patient was referred to the pediatric dentistry clinic with an extensive tooth fracture of the right permanent maxillary lateral incisor. Clinical and radiographic examinations revealed the presence of a complicated crown-root fracture, which had elongated to the buccal subgingival area. The dental history disclosed that the apexification procedure had been started to be performed after his first trauma experience and he had neglected his appointment. The coronal fragment was gently extracted; endodontic treatment was performed; flap surgery was performed to make the fracture line visible. The coronal fragment was reattached to the root fragment with a dual-cure luting composite. A fiber post was stabilized and the access cavity of the tooth was restored with composite resin. At the end of the 24th month, the tooth was asymptomatic, functionally, esthetically acceptable and had no periapical pathology. It is important for the patients undergoing apexification treatment to keep their appointments because of the fracture risk. Restoration of the fractured tooth by preparing retention grooves and a bonding fiber-reinforced post are effective and necessary approaches for successful management.

Objective. The objective of this paper is to report a dental fusion case focusing on clinical and radiographic features for the diagnosis.Method. To report a case of right maxillary lateral incisor fusion and a supernumerary tooth, the anatomy of the root canal and dental united portion were assessed by cone beam computed tomography (CBCT).Results. The clinical examination showed dental juxtaposition with the absence of interdental papilla and esthetic impairment in the right maxillary lateral incisor region. The periapical radiography did not provide enough information for the differential diagnosis due to the inherent limitations of this technique. CBCT confirmed the presence of tooth fusion.Conclusion. CBCT examination supports the diagnosis and provides both the identification of changes in tooth development and the visualization of their extent and limits.

Fusion, an uncommon anomaly of the hard dental tissues, is potentially the cause of clinical problems related to esthetics, tooth spacing, and other periodontal complications. This paper describes a multidisciplinary approach involving surgical, endodontic, restorative, and orthodontic attention for the successful, functional, and esthetic rehabilitation of a maxillary left lateral incisor fused with a supernumerary tooth in unilateral cleft lip adolescence in contralateral side. After clinical and radiographic examinations, a fusion between the left maxillary lateral incisor and a supernumerary tooth was diagnosed in the patient, and a small connection was detected between the pulp systems of the two root canals. The case reported in this paper presents the successful resolution of a fused maxillary lateral incisor with a supernumerary tooth, using endodontic, surgical, restorative, and orthodontic management. The decision made in extracting or retaining the fused tooth depends on the arch discrepancy and esthetic needs. Future studies, with long-term followup, will be helpful in evaluating the long-term efficacy of the different treatment options.

Deficiencies in the alveolar ridges cause multiple problems in achieving aesthetic and functional outcome of implant therapy and are commonly restored by using onlay graft from intraoral source. Careful assessment of the recipient as well as the donor site using cone beam computed tomography (CBCT) is a prerequisite to ideal treatment planning. This paper highlights the critical role of CBCT in planning a successful rehabilitation of traumatised deficient anterior maxillary alveolar ridge using autogenous block graft from mandibular symphysis, followed by implant placement. A 21-year-old male reported with missing right maxillary lateral incisor due to traumatic avulsion 6 months back. A concavity was found on the labial aspect of edentulous area. Serial transplanar images on CBCT revealed gross irregular radiolucency in place of labial cortical plate. Using CBCT, size of the required block was estimated, and mandibular symphyseal area was evaluated for the feasibility of harvesting a graft of suitable dimension. Onlay block graft was harvested from mandibular symphysis and placed at the edentulous site to augment the alveolar ridge. Implants were placed 5 months later and loaded successfully after osseointegration. After 1 year of followup, implant-based prosthesis is working well, without any complications.