Search

Regarding advanced 5G mobile communication, microwave dielectric ceramics are considered as the most potential materials to develop new-generation base station resonators. Herein, ZnNb 2 O 6 ceramics with ε r of approximately 24 have been prepared using the solid-state reaction method, with tailored extra ZnO of x mol% (x = 1, 2 and 3). We have for the first time applied the P-V-L chemical bond theory to investigate ZnNb 2 O 6 ceramics with ZnO doping, by exploring the relationship of dielectric properties and chemical bond characteristics. Particularly, the Raman spectra demonstrates that the full width at half maximum of υ 1 (A g) vibration mode can exhibit significant correlation with the quality factor (Q × f). To further support the experimental study, we have also conducted the first-principle calculation of electron density difference via CASTEP package, which further confirms the change of temperature coefficient of resonance frequency (τ f). Our newly designed ZnNb 2 O 6 ceramics doped with 1 mol% ZnO exhibit excellent dielectric properties, i.e., ε r = 23.74, Q × f = 102,824 GHz and τ f = −55.38 ppm/°C, which demonstrates great potential to construct miniaturized 5G base station with advanced ceramic dielectrics. [ABSTRACT FROM AUTHOR]

The influence of BaO content (up to 15 mol%) on the crystallization behaviour, structure, thermal properties and microwave dielectric properties of the BaO-CaO-B 2 O 3 -SiO 2 glasses and glass-ceramics system was investigated. The glasses were produced by melting at 1400 °C and quenching into water, and the glass-ceramics were produced via heat treatment at temperatures between 750 and 800 °C. The results of X-ray diffraction analysis showed that increasing the BaO content raised the resistance of the glass against crystallization and favoured the transformation of β-CaSiO 3 and α-CaSiO 3 phases, which crystallized in the Ba-free and in low BaO content compositions, into SiO 2 and Ba 4 Si 6 O 16 , which crystallized in compositions with higher concentrations of BaO. The BaO content had little influence on the glass transition temperature ( T g ) and the linear coefficient of thermal expansion (CTE), but strongly reduced the softening point ( T s ). Even the addition of BaO as minor additives resulted in a dramatic reduction of the T s ; for example, the T s decreased from 902 °C for the Ba-free composition to 682 °C for the BaO-containing one (5%). Low values of the dielectric constant (5.9 ≤  ε r ≤ 6.63) and dielectric loss (1.12 × 10 −3 ≤ tan δ  ≤ 3.15 × 10 −3 ) were measured. [ABSTRACT FROM AUTHOR]

Perovskite ceramics with a formula of Ca 0.7 Ti 0.7 La 0.3 Al 0.3 O 3 (CTLA) were produced through a conventional solid-state reaction procedure following three different La 3+ -doping methods using powders of La 2 O 3 , or La 2 O 3 /Al 2 O 3 powder mixture, or LaAlO 3 . La 3+ doping favored grain growth and densification, affected the grain size distribution, and improved the dielectric properties of the produced sintered CTLA ceramics. The doping methods had a strong influence on these properties. More specifically, doping with La 2 O 3 and La 2 O 3 /Al 2 O 3 resulted in formation of solid solution, while a secondary phase formed in the CTLA ceramics doped with LaAlO 3 , which caused a coarsening of the microstructure and lowered the La 3+ doping effects on the dielectric properties. The experimental results suggest that La 3+ doping improves the dielectric properties of the sintered CTLA perovskite ceramics, which are further enhanced by doping with Al 3+ ions in small amounts. However, further increase of Al 3+ ions content jeopardizes them. [ABSTRACT FROM AUTHOR]