Search

Metallurgical solid waste blast furnace water quenched slag (WBFS) was employed as carrier materials to prepare Fe–TiO 2 /WBFS composite photocatalyst using a sol-gel method for improving both the photocatalytic activity and the high-value utilization of metallurgical solid waste. The Fe3+ doping technology was adopted to increase the utilization of solar energy. The influencing factors and photocatalytic activity were systematically evaluated by thermogravimetry/differential thermal analyser (TG-DSC), X-Ray Diffraction (XRD), Brunauer-Emmett-Teller (BET) method, scanning electron microscopy-energy spectrometer (SEM-EDS), X-ray photoelectric spectroscopy (XPS), UV–Vis absorption spectrum and photoluminescence spectra technology through the degradation rate of methylene blue (MB) solution. The results showed that the Fe3+ ions were successfully incorporated into the TiO 2 lattice, which had no effect on the crystalline phase of TiO 2 and expanded the spectral response range of TiO 2 from the ultraviolet region to the visible light region. When the calcination temperature was at 450 °C and the number of Fe–TiO 2 sol loading cycles was two times, the photocatalytic activity of Fe–TiO 2 /WBFS presented the strongest, and the degradation ratio of MB reach the maximum value of 98.9 %. A uniform and dense anatase TiO 2 thin film was wrapped on the surface of WBFS. The photocatalytic activity first improved and then weakened with an increase of calcination temperature, Fe3+ doping amounts and the loading cycles of sol. The TiO 2 film changed from thin to thick and uneven to uniform, until cracking and spalling phenomenon finally occurred with an increase of Fe–TiO 2 sol loading cycle from 1 to 3 times. When the Fe–TiO 2 /WBFS was reused for four times, the degradation rate of MB could still show 67.4 %, being far higher than that of TiO 2 /WBFS of 25.4 %. [ABSTRACT FROM AUTHOR]