Search

Abstract: In Jordan, large amounts of fly ash (FA) are produced as a result of burning heavy fuel in power plants. Extraction of metals from FA is an important industrial/environmental issue to assess metals’ mobility and applications. Large amounts of metals (V, Ni, Fe, Ca, Mg, Na, and K) were easily leached from FA under acidic, basic, and neutral conditions and this makes disposal of this material an important environmental issue. Extraction and separation of vanadium (V) and nickel (Ni) from FA is achieved using Akita''s procedure with some modifications. In the first step, Ni is selectively eluted from FA using NH4OH solution and then precipitated using Na2S. The Ni/V ratio in final precipitate was 27. On the other hand, V is extracted from Ni-free-FA using Na2CO3 solution, recovered by 0.1M tri-ethylamine/toluene, and precipitated by NH4Cl. The V/Ni ratio in the final precipitate was 55. The adopted method showed a reasonable recovery for both metals from FA, 56 and 45% from Ni and V, respectively. The earlier attempts indicated that separation of V/Ni by precipitation using OH− or CO3 2− was not successful where both the metals did not precipitate from solution in the presence of other elements. [Copyright &y& Elsevier]

Abstract: The efficiency of iron coated activated alumina, ferric oxihydroxide and granular activated carbon for the removal of humic substance (HS) from water and wastewater was demonstrated in batch studies. This paper investigated the use of these successful adsorption–adsorbate systems in a continuous flow mode in an effort to obtain the required design and operational data; essential for successful application in water treatment works. The adsorbents were used individually. The influence of the various molecular mass fractions on the adsorption ability of the various systems was considered. Fractionation of humic substances was carried out and low, medium and high molecular mass fractions were produced. Two different column diameters (2.5 and 1cm) were used in the experimental runs. The smaller diameter column was used for experiments dealing with the lower molecular weigh humics as these are very difficult to produce in large enough quantities to carry out continuous adsorption runs in the traditional 2.5cm diameter laboratory adsorption columns. The dissolved organic content (DOC), ultraviolet (UV) absorbance and specific ultraviolet absorbance (SUVA) values were measure and analysed under different operating conditions. Furthermore, the experimental results were modelled using the Thomas model and the empty bed contact time model (EBCT). The Mass Transfer Zone was also analysed for all cases. The results indicated strongly the influence of molecular mass in the adsorption of humic substances. In addition, two distinctive features appear from these results; GAC is able to remove high MM although lacking of mesoporosity (attributed to precipitation and alteration of HS conformation) and β-FeOOH does not show such a high adsorption capacity as previously predicted, attributed to the non-equilibrium state and to the lack of surface under the media compaction. [Copyright &y& Elsevier]