Search

The synergistic combination of different nanomaterials for improved performance in environmental applications such as the removal of aqueous micropollutants has attracted increasing interest in recent years. This study demonstrates a novel sequential adsorption–aggregation concept that harnesses tubular halloysite nanotubes (HNTs) and flexible cellulose nanofibrils (CNFs) for the removal of a small, anionic dye molecule, chrome azurol S, from water. Hollow HNTs were first allowed to interact with the aqueous dye solution, after which the dye-loaded colloidal nanotubes were aggregated and separated from the water phase with cationized CNFs. The combination of 25 mg CNFs with 1 g HNTs at pH 7 resulted in efficient removal of dye (80%) and turbidity (~100%) and the removal of dye was further promoted in more acidic conditions (within the pH range of 6–8.5) because of the attractive electrostatic interactions. Cationic CNFs not only enabled the separation of dye-loaded clay particles from the water phase through a rapid aggregation but also participated in dye removal through adsorption (~20%). In comparison with nano-sized HNTs, the dye removal performance of micro-sized and chemically similar kaolin was poor (43%). Given the good availability of both HNTs and CNFs and the low consumption of the more expensive component (i.e., CNFs) in the process, the concept is straightforward, readily applicable, environmentally benign, and potentially cost-effective.

Micropollutants escaping conventional wastewater treatment processes pose a threat to biota and the environment. Amongst micropollutants, small and ionizable organic compounds are particularly challenging, since their removal depends significantly on prevailing conditions. In this study, anionic cellulose nanofibrils (CNFs) were shown to perform as promising adsorbents for an ionizable pharmaceutical, salbutamol. The adsorbents were produced from wood cellulose through succinylation pretreatment in urea-LiCl deep eutectic solvent (DES), followed by a nanofibrillation procedure. The impact of pH, contact time, salbutamol concentration, and adsorbent dose on salbutamol uptake were investigated in batch adsorption studies. Based on the results, the chemical modification of cellulose significantly enhanced the adsorption of salbutamol. The adsorption efficiency was mainly dependent on the charge and colloidal stability of the anionic nanofibril suspension rather than the charge of salbutamol, because the adsorption was considerably improved at pH > 7 due to the deprotonation of the cellulose carboxyl groups. The experimental maximum adsorption capacity was 196 mg/g. This study highlights the potential of cellulose nanomaterial adsorbents and the importance of controlling the charge of the adsorbent material when developing solutions for ionizable micropollutant removal.