Search

Pt nanoparticles are typically decorated as co‐catalyst on semiconductors to enhance the photocatalytic performance. Due to the low abundance and high cost of Pt, reaching a high activity with minimized co‐catalyst loadings is a key challenge in the field. We explore a dewetting‐dealloying strategy to fabricate on TiO2 nanotubes nanoporous Pt nanoparticles, aiming at improving the co‐catalyst mass activity for H2 generation. For this, we sputter first Pt‐Ni bi‐layers of controllable thickness (nm range) on highly ordered TiO2 nanotube arrays, and then induce dewetting‐alloying of the Pt‐Ni bi‐layers by a suitable annealing step in a reducing atmosphere: the thermal treatment causes the Pt and Ni films to agglomerate and at the same time mix with each other, forming on the TiO2 nanotube surface metal islands of a mixed PtNi composition. In a subsequent step we perform chemical dealloying of Ni that is selectively etched out from the bimetallic dewetted islands, leaving behind nanoporous Pt decorations. Under optimized conditions, the nanoporous Pt‐decorated TiO2 structures show a>6 times higher photocatalytic H2 generation activity compared to structures modified with a comparable loading of dewetted, non‐porous Pt. We ascribe this beneficial effect to the nanoporous nature of the dealloyed Pt co‐catalyst, which provides an increased surface‐to‐volume ratio and thus a more efficient electron transfer and a higher density of active sites at the co‐catalyst surface for H2 evolution. [ABSTRACT FROM AUTHOR]

Self-standing TiO2 nanotube layers in the form of membranes are fabricated by self-organizing anodization of Ti metal and a potential shock technique. The membranes are then decorated by sputtering different Pt amounts i) only at the top, ii) only at the bottom or iii) at both top and bottom of the tube layers. The Pt-decorated membranes are transferred either in tube top-up or in tube top-down configuration onto FTO slides and are investigated, after crystallization, as photocatalysts for H2 generation using either front or back-side light irradiation. Double-side Pt-decoration of the tube membranes leads to higher H2 generation rates (independently of tube and light-irradiation configuration) compared to membranes decorated at only one side with similar overall Pt amounts. The results suggest that this effect cannot be only ascribed to the overall amount of Pt co-catalyst as such but also to its distribution at both tube extremities. This leads to optimized light absorption and electron diffusion/transfer dynamics: the central part of the membranes acts as light-harvesting zone and electrons therein generated can diffuse towards the Pt/TiO2 active zones (tube extremities) where they can react with the environment and generate H2. [ABSTRACT FROM AUTHOR]

In the present work we investigate various optical properties (such as light absorption and reflectance) of anodic TiO2 nanotube layers directly transferred as self-standing membranes onto quartz substrates. This allows investigation in a transmission geometry which provides significantly more reliable data than measurements on the metallic Ti substrate. Light transmission and reflectance measurements were carried out for layers of thickness varying from 1.8 to 50 μm, and the layers were investigated in their amorphous and crystalline forms. A series of wavelength-dependent light attenuation coefficients are extrapolated and found to match the photocurrent versus irradiation wavelength behavior. A feature specific to anodic nanotubes is that their intrinsic carbon contamination content causes a proportional sub-bandgap response. Overall, the extracted data provide a valuable basis and understanding for the design of photo-electrochemical devices based on TiO2 nanotubes. [ABSTRACT FROM AUTHOR]