Search

This article reports biodegradation rates for a commercial dispersant, JD-2000, South Louisiana crude oil (SLC) alone, and SLC dispersed with JD-2000 at 5 and 25 °C. Results from the biodegradation experiments revealed that Component X, a chemical marker for JD-2000, rapidly degraded at both temperatures. The application of JD-2000 decreased by half the overall biodegradation rate of aliphatic compounds at 25 °C. At 5 °C, a residual fraction consisting of iso- and n-alkanes (C29-C35) persisted after 56 d. The combination of dispersant and higher temperature resulted in faster removal rates for 2- and 3-ring polycyclic aromatic hydrocarbons. When compared with Corexit 9500, our results suggest that the chemistry of the surfactant (or surfactants) in JD-2000 might have favored oil dissolution (substrate transport to the aqueous phase) as an uptake mechanism over adhesion, which requires direct contact of the biomass with the oil., (Copyright © 2015 Elsevier Ltd. All rights reserved.)

Addition of granular materials to floating crude oil slicks can be effective in capturing and densifying the floating hydrophobic phase, which settles by gravity. Interaction of light hydrophobic liquids (LHL) with quartz sand was investigated in LHL-salt water systems. The LHLs studied were decane, tetradecane, hexadecane, benzene, toluene, ethylbenzene, m-xylene, and 2-cholorotoluene. Experiments were conducted with fine quartz sand (passing sieve No. 40 with openings 0.425 mm). Each LHL was dyed with few crystals of Sudan IV dye for ease of visual observation. A volume of 0.5 mL of each LHL was added to 100 mL salt water (34 g/L). Addition of one gram of quartz sand to the floating hydrophobic liquid layer resulted in formation of sand-encapsulated globules, which settled due to increased density. All LHLs (except for a few globules of decane) formed globules covered with fine sand particles that were heavy enough to settle by gravity. The encapsulated globules were stable and retained their shape upon settling. Polarity of hydrophobic liquids as the main factor of aggregation with minerals was found to be insufficient to explain LHL aggregation with sand. Contact angle measurements were made by submerging a large quartz crystal with the LHL drop on its surface into salt water. A positive correlation was observed between the wetting angle of LHL and the LHL volume captured (r = 0.75). The dependence of the globule density on globule radius was analyzed in relation to the coverage (%) of globule surface (LHL-salt water interface) by fine quartz particles., (Copyright © 2015 Elsevier Ltd. All rights reserved.)

An analytical method has been developed for the pressurized liquid extraction (PLE) of a wide range of semi-volatile organic compounds (SVOCs) from atmospheric particulate matter. Approximately 130 SVOCs from eight compound classes were selected as molecular markers of (1) agricultural activity (30 current and historic-use pesticides), (2) industrial activity (18 PCBs), (3) consumer products and building materials (16 PBDEs, 11 OPEs), and (4) motor vehicle exhaust (22 PAHs, 16 alkanes, 9 hopanes, 8 steranes). Currently, there is no analytical method validated for the extraction of all eight compound classes in a single automated technique. The extraction efficiencies of varying solvents and solvent combinations at high temperatures and pressures were examined. Extracts were concentrated and analyzed by gas chromatography coupled with mass spectrometry. The optimized PLE method utilized methylene chloride:acetone (2:1 v/v) at 100 °C with three (5 min) static cycles, flush volume of 80%, and a 100 s N2 purge. Spike and recovery experiments (n=7) provided average percent recoveries for pesticides, PCBs, PBDEs, OPEs, PAHs, alkanes, hopanes, and steranes of 88.8±4.0%, 86.9±2.6%, 83.8±2.9%, 101±6%, 90.3±6.1%, 74.4±8.8%, 104±8%, and 86.5±8.6%, respectively. The developed method was applied to atmospheric particulate matter samples collected in the greater Houston, TX metropolitan area. Ambient concentrations of eight classes of compounds (92 SVOCs) were reported in pg m(-3)., (Copyright © 2015 Elsevier Ltd. All rights reserved.)

The molecular scale sorption, diffusion and distribution of asphaltene, resin, aromatic and saturate fractions of heavy crude oil on quartz surface were studied using molecular dynamic simulation. Sorption of saturates on quartz decreased by 31% when temperature increased from 298 to 398K while opposite trend was observed for resins, but insignificant changes were found in asphaltenes and aromatics. Despite of this variety, the main contribution of interactions was van der Waals energy (>90%) irrespective of molecular components and temperatures. The diffusion coefficient of saturates was predicted as 10.8×10(-10)m(2)s(-1) while that of the remaining fractions was about 4×10(-10)m(2)s(-1) at 298K. The most likely oil distribution on quartz surface was that aromatics and saturates transported randomly into and out of the complex consisting of asphaltenes surrounded by resins, which was influenced by temperature. Overall, the knowledge on quartz-oil and oil-oil interactions gained in this study is essential for future risk assessment and remediation activities as previous studies on soil remediation either limited to light oil fractions with <40 carbons or treated the heavy crude oil as a single pseudo entity ignoring the interactions between oil fractions., (Copyright © 2013 Elsevier Ltd. All rights reserved.)

A key component to predicting the success of utilizing surfactants to enhance the removal of organic liquids from soil system is quantifying micellar solubilization kinetics. In this study, a flow reactor was employed to investigate the influence of surfactant ethoxylate chain length on the rates of solubilization of octane, decane, and dodecane in micellar solutions of a homologous series of purified dodecyl alcohol ethoxylates. Effluent concentration data were fit using a finite element model utilizing a linear-driving-force model to represent mass transfer at the interface. For flow rates between 0.1 and 2 ml min(-1), mass transfer coefficients ranged from 5 x 10(-8) to 7 x 10(-7)m s(-1) and did not vary in a systematic way with either solute structure or surfactant ethoxylate chain length and were lower than those found in pure water. Correlations developed for the Sherwood number based on diffusion coefficients of surfactant micelles containing organic material (organic-laden micelle) exhibit a velocity dependence similar to that found for systems based on aqueous diffusion. These results suggest that under gentle flowing conditions, the mass transfer is limited by diffusion of the organic-laden micelle. Although these trends are specific for this experimental system, the results demonstrate the importance of selecting the proper diffusion coefficient when modeling surfactant solubilization processes.

Short chain (C10-C13) polychloro-n-alkanes (sPCAs) mixtures were synthesized by refluxing pure n-alkane (> 99%) with sulfuryl chloride (SO2Cl2) in the presence of UV-light (550 W). The free radical initiated reactions produced analogs containing approximately 4-9 chlorine atoms on each carbon chain. Purification of reaction products was achieved by adsorption chromatography on Florisil. The products were characterized by high-resolution gas chromatography/mass spectrometry (HRGC/MS) operated in the electron capture negative ionization (ECNI) and in electron ionization (EI) modes. Individual standards can now be combined to create standards whose profiles resemble that of environmental samples. Quantification of a known amount of the newly synthesized sPCAs mixture, using an industrial formulation as an external standard, resulted in an overestimation (approximately 28%) in its true value.