Search

Abstract An increasing number of researchers have researched fixture layout optimization for thin-walled part assembly during the past decades. However, few papers systematically review these researches. By analyzing existing literature, this paper summarizes the process of fixture layout optimization and the methods applied. The process of optimization is made up of optimization objective setting, assembly variation/deformation modeling, and fixture layout optimization. This paper makes a review of the fixture layout for thin-walled parts according to these three steps. First, two different kinds of optimization objectives are introduced. Researchers usually consider in-plane variations or out-of-plane deformations when designing objectives. Then, modeling methods for assembly variation and deformation are divided into two categories: Mechanism-based and data-based methods. Several common methods are discussed respectively. After that, optimization algorithms are reviewed systematically. There are two kinds of optimization algorithms: Traditional nonlinear programming and heuristic algorithms. Finally, discussions on the current situation are provided. The research direction of fixture layout optimization in the future is discussed from three aspects: Objective setting, improving modeling accuracy and optimization algorithms. Also, a new research point for fixture layout optimization is discussed. This paper systematically reviews the research on fixture layout optimization for thin-walled parts, and provides a reference for future research in this field.

An increasing number of researchers have researched fixture layout optimization for thin-walled part assembly during the past decades. However, few papers systematically review these researches. By analyzing existing literature, this paper summarizes the process of fixture layout optimization and the methods applied. The process of optimization is made up of optimization objective setting, assembly variation/deformation modeling, and fixture layout optimization. This paper makes a review of the fixture layout for thin-walled parts according to these three steps. First, two different kinds of optimization objectives are introduced. Researchers usually consider in-plane variations or out-of-plane deformations when designing objectives. Then, modeling methods for assembly variation and deformation are divided into two categories: Mechanism-based and data-based methods. Several common methods are discussed respectively. After that, optimization algorithms are reviewed systematically. There are two kinds of optimization algorithms: Traditional nonlinear programming and heuristic algorithms. Finally, discussions on the current situation are provided. The research direction of fixture layout optimization in the future is discussed from three aspects: Objective setting, improving modeling accuracy and optimization algorithms. Also, a new research point for fixture layout optimization is discussed. This paper systematically reviews the research on fixture layout optimization for thin-walled parts, and provides a reference for future research in this field. [ABSTRACT FROM AUTHOR]

Abstract Thin-walled parts are typically difficult-to-cut components due to the complex dynamics in cutting process. The dynamics is variant for part during machining, but invariant for machine tool. The variation of the relative dynamics results in the difference of cutting stage division and cutting parameter selection. This paper develops a novel method for whole cutting process optimization based on the relative varying dynamic characteristic of machining system. A new strategy to distinguish cutting stages depending on the dominated dynamics during machining process is proposed, and a thickness-dependent model to predict the dynamics of part is developed. Optimal cutting parameters change with stages, which can be divided by the critical thickness of part. Based on the dynamics comparison between machine tool and thickness-varying part, the critical thicknesses are predicted by an iterative algorithm. The proposed method is validated by the machining of three benchmarks. Good agreements have been obtained between prediction and experimental results in terms of stages identification, meanwhile, the optimized parameters perform well during the whole cutting process.

Thin-walled parts are typically difficult-to-cut components due to the complex dynamics in cutting process. The dynamics is variant for part during machining, but invariant for machine tool. The variation of the relative dynamics results in the difference of cutting stage division and cutting parameter selection. This paper develops a novel method for whole cutting process optimization based on the relative varying dynamic characteristic of machining system. A new strategy to distinguish cutting stages depending on the dominated dynamics during machining process is proposed, and a thickness-dependent model to predict the dynamics of part is developed. Optimal cutting parameters change with stages, which can be divided by the critical thickness of part. Based on the dynamics comparison between machine tool and thickness-varying part, the critical thicknesses are predicted by an iterative algorithm. The proposed method is validated by the machining of three benchmarks. Good agreements have been obtained between prediction and experimental results in terms of stages identification, meanwhile, the optimized parameters perform well during the whole cutting process. [ABSTRACT FROM AUTHOR]