Search

Pressure–temperature conditions of tourmaline breakdown in a metapelite were determined by high-pressure experiments at 700–900°C and 4–6 GPa. These experiments produced an eclogite–facies assemblage of garnet, clinopyroxene, phengite, coesite, kyanite and rare rutile. The modal proportions of tourmaline clearly decreased between 4.5 and 5 GPa at 700°C, between 4 and 4.5 GPa at 800°C, and between 800 and 850°C at 4 GPa, with tourmaline that survived the higher temperature conditions appearing corroded and thus metastable. Decreases in the modal abundance of tourmaline are accompanied by decreasing modal abundance of coesite, and increasing that of clinopyroxene, garnet and kyanite; the boron content of phengite increases significantly. These changes suggest that, with increasing pressure and temperature, tourmaline reacts with coesite to produce clinopyroxene, garnet, kyanite, and boron-bearing phengite and fluid. Our results suggest that: (1) tourmaline breakdown occurs at lower pressures and temperatures in SiO2-saturated systems than in SiO2-undersaturated systems. (2) In even cold subduction zones, subducting sediments should release boron-rich fluids by tourmaline breakdown before reaching depths of 150 km, and (3) even after tourmaline breakdown, a significant amount of boron partitioned into phengite could be stored in deeply subducted sediments. [ABSTRACT FROM AUTHOR]

The phase relations of iron-rich olivine and its high-pressure polymorphs are important for planetary science and meteoritics because these minerals are the main constituents of terrestrial mantles and meteorites. The olivine–ahrensite binary loop was previously determined by thermochemical calculations in combination with high-pressure experiments; however, the transition pressures contained significant uncertainties. Here we determined the binary loop of the olivine–ahrensite transition in the (Mg,Fe)2SiO4 system at 1740 K in the pressure range of 7.5–11.2 GPa using a multi-anvil apparatus with the pressure determined using in situ X-ray diffraction, compositional analysis of quenched run products, and thermochemical calculation. Based on the determined binary loop, a user-friendly software was developed to calculate pressure from the coexisting olivine and ahrensite compositions. The software is used to estimate the shock conditions of several L6-type chondrites. The obtained olivine–ahrensite phase relations can also be applied for precise in-house multi-anvil pressure calibration at high temperatures. [ABSTRACT FROM AUTHOR]

MgSiO akimotoite is stable relative to majorite-garnet under low-temperature geotherms within steeply or rapidly subducting slabs. Two compositions of Mg-akimotoite were synthesized under similar conditions: Z674 (containing about 550 ppm wt HO) was synthesized at 22 GPa and 1,500 °C and SH1101 (nominally anhydrous) was synthesized at 22 GPa and 1,250 °C. Crystal structures of both samples differ significantly from previous studies to give slightly smaller Si sites and larger Mg sites. The bulk thermal expansion coefficients of Z674 are (153-839 K) of a = 20(3) × 10 K and a = 17(2) × 10 K, with an average of α = 27.1(6) × 10 K. Compressibility at ambient temperature of Z674 was measured up to 34.6 GPa at Sector 13 (GSECARS) at Advanced Photon Source Argonne National Laboratory. The second-order Birch-Murnaghan equation of state (BM2 EoS) fitting yields: V = 263.7(2) Å, K = 217(3) GPa ( K′ fixed at 4). The anisotropies of axial thermal expansivities and compressibilities are similar: α = 8.2(3) and α = 10.68(9) (10 K); β = 11.4(3) and β = 15.9(3) (10 GPa). Hydration increases both the bulk thermal expansivity and compressibility, but decreases the anisotropy of structural expansion and compression. Complementary Raman and Fourier transform infrared (FTIR) spectroscopy shows multiple structural hydration sites. Low-temperature and high-pressure FTIR spectroscopy (15-300 K and 0-28 GPa) confirms that the multiple sites are structurally unique, with zero-pressure intrinsic anharmonic mode parameters between −1.02 × 10 and +1.7 × 10 K, indicating both weak hydrogen bonds (O-H···O) and strong OH bonding due to long O···O distances. [ABSTRACT FROM AUTHOR]

We report the first study of electrical conductivities of silicate melts at very high pressures (up to 10 GPa) and temperatures (up to 2,173 K). Impedance spectroscopy was applied to dry and hydrous albite (NaAlSiO) glasses and liquids (with 0.02-5.7 wt% HO) at 473-1,773 K and 0.9-1.8 GPa in a piston-cylinder apparatus, using a coaxial cylindrical setup. Measurements were also taken at 473-2,173 K and 6-10 GPa in two multianvil presses, using simple plate geometry. The electrical conductivity of albite melts is found to increase with temperature and water content but to decrease with pressure. However, at 6 GPa, conductivity increases rapidly with temperature above 1,773 K, so that at temperatures beyond 2,200 K, conductivity may actually increase with pressure. Moreover, the effect of water in enhancing conductivity appears to be more pronounced at 6 GPa than at 1.8 GPa. These observations suggest that smaller fractions of partial melt than previously assumed may be sufficient to explain anomalously high conductivities, such as in the asthenosphere. For dry melt at 1.8 GPa, the activation energy at T > 1,073 K is higher than that at T < 1,073 K, and the inflection point coincides with the rheological glass transition. Upon heating at 6-10 GPa, dry albite glass often shows a conductivity depression starting from ~1,173 K (due to crystallization), followed by rapid conductivity enhancement when temperature approaches the albite liquidus. For hydrous melts at 0.9-1.8 GPa, the activation energies for conductivity at ≥1,373 K are lower than those at <973 K, with a complex transition pattern in between. Electrical conductivity and previously reported Na diffusivity in albite melt are consistent with the Nernst-Einstein relation, suggesting the dominance of Na transport for electrical conduction in albite melts. [ABSTRACT FROM AUTHOR]

In situ observations of the zircon-reidite transition in ZrSiO4 were carried out using a multianvil high- pressure apparatus and synchrotron radiation. The phase boundary between zircon and reidite was determined to be P (GPa) = 8.5+0.0017×(T-1200) (K) for temperatures between 1100–1900 K. When subducted slabs, including igneous rocks and sediments, descend into the upper mantle, the zircon in the subducted slab transforms into reidite at pressures of about 9 GPa, corresponding to a depth of 270 km. Reidite found in an upper Eocene impact ejecta layer in marine sediments is thought to have been transformed from zircon by a shock event. The peak pressure generated by the shock event in this occurrence is estimated to be higher than 8 GPa. [ABSTRACT FROM AUTHOR]