Search

Cobalt(ii)-containing ionic liquids were synthesized using N,N-dimethylformamide, N-methylpyrrolidone (NMP), dimethylsulfoxide (DMSO), N,N-dimethylacetamide (DMAc), pyridine-N-oxide (py-O), 1,10-phenanthroline (phen), ethylenediamine (en) and dimethylimidazolidinone (DMI) as ligands. The weakly coordinating bis(trifluoromethylsulfonyl)imide (Tf2N−) was used as a counter anion. Several compounds had a melting temperature below 100 °C, and the compound [Co(DMAc)6][Tf2N]2 was liquid at room temperature, with a viscosity of only 18 mPa s at 80 °C. Several compounds were recrystallized to give high quality single crystals and their crystal structures were determined. EXAFS measurements were performed on [Co(DMAc)6][Tf2N]2 at different temperatures and it was observed that the [Co(DMAc)6]2+ ion partially dissociated at higher temperatures, which explains the temperature-dependent color change (thermochromism). The electrochemical properties of the compounds with the lowest melting points were also investigated. Adherent, crack-free metallic cobalt layers could be electrodeposited from [Co(DMAc)6][Tf2N]2, [Co(DMI)6][Tf2N]2 and [Co(NMP)6][Tf2N]2. From the first two, black deposits consisting of micrometer-sized needles were obtained, whereas the latter resulted in a dull grey cobalt layer consisting of micrometer-sized cobalt spheres. The Co(iii)/Co(ii) redox couple was not found to occur in any compound with an O-donor ligand, but the Co(iii)/Co(ii) redox couple was found to be quasi-reversible for [Co(phen)3][Tf2N]2 dissolved in [BMP][Tf2N]. [ABSTRACT FROM AUTHOR]

Cobalt(ii)-containing liquid metal salts (LMS) with N-alkylimidazole ligands and bis(trifluoromethanesulfonyl)imide (bistriflimide, Tf2N−) or methanesulfonate (mesylate, OMs−) anions were synthesized and characterized. The chain length of the alkyl side chain on the imidazole ligand was varied. All compounds were characterized using CHN analysis, DSC and FTIR measurements. Single-crystal X-ray diffraction measurements were performed on six of the compounds for which single crystals of good quality could be obtained. All cobalt(ii) centers are six-coordinate with the N-alkylimidazole ligands in an octahedral configuration and the anions are non-coordinating. The same coordination environment was observed by EXAFS measurements on cobalt(ii) liquid metal salts in the liquid state. The electrochemical properties of the compounds with the lowest melting temperatures were investigated using cyclic voltammetry. It was found that part of the current was consumed in the electrodeposition of cobalt, whereas the other part of the current was consumed in the electrochemical formation of cobalt(0) nanoparticles. [ABSTRACT FROM AUTHOR]

Manganese(ii)-containing ionic liquids were synthesized, in which the manganese atoms are coordinated by glymes (diglyme, triglyme, tetraglyme), pyridine-N-oxide, dimethylsulfoxide or N-alkylimidazoles (N-methylimidazole, N-butylimidazole and N-hexylimidazole). As anion, bis(trifluoromethanesulfonyl)imide (bistriflimide, Tf2N−), trifluoromethanesulfonate (triflate, OTf−) or methanesulfonate (mesylate, OMs−) were used. The compounds were characterized by CHN analysis, FTIR, DSC and single-crystal X-ray diffraction measurements. All manganese atoms were six-coordinate. It was found that the glyme-type ligands were replaced by atmospheric water upon leaving the crystals open to the air for several days. The crystal structures of seven compounds were described in detail and the compounds with the lowest melting temperatures were tested as electrolytes for the electrodeposition of manganese (thin) films. An irreversible reduction wave from Mn(ii) to Mn(0) and granular manganese deposits were observed for all compounds, except for liquid manganese salts with N-alkylimidazole ligands and bistriflimide anions, where the electrochemical formation of manganese nanoparticles was observed instead of the deposition of a manganese layer. However, for compounds with the same cation but with a triflate or methanesulfonate anion, manganese metal deposits were obtained, indicating that the nature of the anion has an important effect on the electrochemical properties of liquid metal salts. [ABSTRACT FROM AUTHOR]

A new azide functionalized Anderson polyoxometalate was synthesized, fully characterized and subsequently used as a building block for further POM post-functionalization with organic compounds through a copper catalyzed azide–alkyne cycloaddition (CuAAC) reaction. Optimization of the reaction conditions led to an efficient, fast, convenient and versatile POM coupling method. [ABSTRACT FROM AUTHOR]

The ionic liquid choline bis(trifluoromethylsulfonyl)imide, [Chol][Tf2N], was used for the extraction of neodymium(III), in combination with choline hexafluoroacetylacetonate, [Chol][hfac], as the extractant. The binary mixture of [Chol][Tf2N] and water shows temperature-dependent phase behavior, with an upper critical solution temperature of 72 °C. A novel extraction technique, homogeneous liquid-liquid extraction (HLLE), was applied to this solvent system. HLLE is based on the use of thermomorphic solvent mixtures and has the advantage of forming a homogeneous phase during mixing. Extraction is not kinetically hindered by an interface and the extraction equilibrium is reached faster than in the case of heterogeneous mixing in conventional solvent extraction. Several extraction parameters were studied for the extraction of neodymium(III) with [Chol][hfac]: temperature, pH, extractant concentration and loading of the ionic liquid phase. A speciation study was performed to determine the stoichiometry of the extracted neodymium(III) complex and a plausible extraction mechanism is proposed. Neodymium is extracted as a tetrakis hexafluoroacetylacetonate complex with one choline cation as counter ion. The crystal structure of the extracted complex showed the presence of a coordination bond between the choline counter ion and the neodymium(III) center, resulting in a coordination number of nine. The stripping of the loaded neodymium and the influence of acid and extractant concentrations on the phase behavior of the [Chol][Tf2N]-H2O system were investigated. [ABSTRACT FROM AUTHOR]

Metal oxides were found to dissolve in different imidazolium ionic liquids with a hydrogen atom in the C2 position of the imidazolium ring, but not if a methyl substituent was present in the C2 position. The crystal structure of the product that crystallised from an ionic liquid containing dissolved silver(I) oxide showed that this was a silver(I) carbene complex. The presence of carbenes in solution was proven by 13C NMR spectroscopy and the reactions were also monitored by Raman spectroscopy. The dissolution of other metal oxides, namely copper(II) oxide, zinc(II) oxide and nickel(II) oxide, was also studied in imidazolium ionic liquids and it was found that stable zinc(II) carbenes were formed in solution, but these did not crystallise under the given experimental conditions. A crystalline nickel(II) carbene complex could be obtained from a solution of nickel(II) chloride dissolved in a mixture of 1-butyl-3-methylimidazolium and 1-ethyl-3-methylimidazolium acetate. [ABSTRACT FROM AUTHOR]

In view of preparing Cu polynuclear complexes with dipyrromethene ligands, the mononuclear complexes [Cu(ii)(dipy)2] (dipyH = 5-phenyldipyrromethene) and [Cu(ii)(dpdipy)2] (dpdipyH = 1,5,9-triphenyldipyrromethene) have been prepared and characterized by X-ray crystallography, mass spectrometry and EPR spectroscopy. Their peculiar redox and spectroscopic (absorption/emission) behaviours are discussed. In contrast to CuII complexes of 1,1′-bidypyrrin, the reduction electrolysis of [Cu(ii)(dpdipy)2] leads to decomposition products on a time scale of a few hours. Moreover in relation to this observation, [Cu(i)(dpdipy)2]− could not be synthesized in spite of the CuI core protection by the phenyl substituents in ortho position of the nitrogen atoms. Theoretical calculations provide some explanations for this instability. Interestingly [Cu(ii)(dipy)2] and [Cu(ii)(dpdipy)2] display weak luminescence at room temperature, attributed to a ligand centered emission. [ABSTRACT FROM AUTHOR]