Search

The infrastructure is in many countries aging and continuous maintenance is required to ensure the safety of the structures. For concrete structures, cracks are a part of the structure's life cycle. However, assessing the structural impact of cracks in reinforced concrete is a complex task. The purpose of this paper is to present a dataset that can be used to verify and compare the results of the measured crack propagation in concrete with the well-known Digital Image Correlation (DIC) technique and with Crack Monitoring from Motion (CMfM), a novel photogrammetric algorithm that enables high accurate measurements with a non-fixed camera. Moreover, the data can be used to investigate how existing cracks in reinforced concrete could be implemented in a numerical model. Therefore, the first potential area to use this dataset is within image processing techniques with a focus on DIC. Until recently, DIC suffered from one major disadvantage; the camera must be fixed during the entire period of data collection. Naturally, this decreases the flexibility and potential of using DIC outside the laboratory. In a recently published paper (Belloni et al., 2023), an innovative photogrammetric algorithm (CMfM) that enables the use of a moving camera, i.e. a camera that is not fixed during data acquisition, was presented. The imagery of this dataset (Sjölander et al., 2023) was used to verify the potential of this algorithm and could be used to validate other approaches for non-fixed cameras. The second potential area is structural engineering. The data can be used to verify non-linear material models used in finite element (FE) software to simulate the structural response of reinforced concrete. In particular, the data can be used to investigate how existing cracks should be modelled in a FE model. The dataset presented in this paper includes data collected from a three-point bending test performed in a laboratory environment on uncracked and pre-cracked reinforced concrete beams. Structural testing was performed using a displacement-controlled set-up, which continuously recorded the force and the vertical displacement of a centric placed loading piston. First, the response of three uncracked beams was recorded. Thereafter, photos of the resulting cracks were taken, and a detailed mapping was presented. Material properties for the concrete, e.g., compressive strength, are presented together with testing of the tensile capacity of the reinforcement and a compressive test of the soft fiber boards used at the support to ensure good contact between steel and concrete. Then, the structural response of the pre-cracked beams was tested. During this test, four fixed cameras were used to monitor the crack propagation at different locations on the beam. Images are presented at the start of the load sequences and at pre-defined load stops during the testing. Hence, the crack opening captured in the images can be correlated to the force-displacement data. Moreover, a non-fixed camera was used to capture additional imagery at the location of each fixed camera., (© 2023 The Author(s).)