Search

This study focuses on enhancing the mechanical strength of aquaporin (AQP)-based biomimetic membranes for seawater desalination. AQP incorporated vesicles were embedded into the selective layer of an optimized thin film composite (TFC) membrane. The resultant membrane, denoted as ASW, exhibited a stable water flux around 20 L·m−2·h−1 and 99% NaCl rejection at a constant pressure of 55 bar using 32,000 mg·L−1 NaCl solution as feed in reverse osmosis (RO) measurement. The robustness of the ASW membranes were evaluated. The water flux of ASW membrane was almost 100% enhanced compared with that of AQP-free control TFC membranes. The filtration performance of the ASW membrane was further evaluated by a seven-day desalination test using a real seawater secondary effluent collected from a desalination plant in Singapore as feed. To our best knowledge, our study is the first report on the AQP-incorporated RO membrane applied for seawater desalination. A commercial SW30HR membrane was tested in parallel for comparison. The robust ASW membrane exhibited a nearly 80% higher water flux in comparison to the SW30HR membrane with a comparable overall solute rejection, suggesting the advantage and feasibility of Aquaporin based biomimetic membranes for seawater desalination. • The mechanical strength of aquaporin incorporated polyamide layer was characterized with AFM. • The effects of high pressure compaction and salinity on aquaporin incorporated polyamide layer were investigated. • The aquaporin based biomimetic membranes were optimized for seawater desalination (SWRO) application. • A seven-day SWRO measurement of the ASW was conducted using a real seawater secondary effluent. [ABSTRACT FROM AUTHOR]

The ultra-permeable membranes (UPMs) are expected to reduce the specific energy consumption (SEC) of desalination, but the potential of UPMs in hollow fiber configuration has not been well quantified. Herein, we analyse the SEC and footprints of UPM modules in three feed salinities: seawater reverse osmosis (SWRO), brackish water RO (BWRO) and low-pressure RO (LPRO). Through the modelling the fluid dynamics and mass transport of RO systems, we find that a tripling in spiral-wound SWRO membrane permeability (based on the current value of 1 L m−2 h−1 bar−1; LMH/bar) could result in 16% decrease in SEC. Contrastingly, the quadrupling of hollow fiber SWRO membrane permeability (based on the current value of 0.25 LMH/bar) could reduce the SEC by 23%. According to our analysis, hollow fiber and spiral-wound SWRO membranes with permeabilities up to 1 LMH/bar and 3 LMH/bar, respectively, can reduce the SEC of seawater desalination. On the other hand, membranes with permeabilities up to 9 LMH/bar and 12 LMH/bar can lead to SEC savings in BWRO and LPRO desalination, respectively. This study provides a general guidance to RO membrane researchers on the permeability upper-limit of which UPMs could bring about SEC and footprint savings at a system level. [Display omitted] • Energy savings achievable by high permeability RO membranes were quantified. • Modelling was performed by simulating fluid dynamics in various RO configurations. • Hollow fiber SWRO membranes (up to 1 LMH/bar) could reduce energy consumption. • Spiral-wound SWRO membranes (up to 3 LMH/bar) could reduce energy consumption. • High permeability RO membranes could bring about greater benefits in BWRO/LPRO. [ABSTRACT FROM AUTHOR]