Search

The effects of ash and sulfur content on the morphology of particulate matter (PM) in diesel particle filter (DPF) were investigated with five different components of lubricants. The aggregate morphology of primary particles in diesel were analyzed using transmission electron microscopy (TEM). The fractal dimensions of carbon particles were calculated by box-counting method (BCM), differential box-counting method (DBC), relative differential box-counting method (RDBC) and MAD-based box counting method (MAD-DBC), and the results were compared. The results showed that the microstructure of PM developed from chain-like structure to agglomerate structure with the increase of sulfur and ash content in lubricating oil. The fractal dimension of carbon particles increased with the increase of sulfur and ash content. The SSE of RDBC fitting results was smaller, and the R-square is larger. MAD-DBC fitting results had stronger anti-noise interference performance.

This study involved conducting an experimental and numerical investigation on the effects of the air-to-fuel ratio (AFR), engine speed, and engine load on the inlet gas component of a three-way catalyst (TWC) and on the effects of noble metal loading, noble metal ratio, and carrier pore density on the emission conversion efficiency. The results showed that AFR can significantly affect the raw emissions of NOx and THC, and better emission conversion efficiency of a TWC can be reached when AFR is controlled between 0.995 to 1. Compared with engine speed, engine load has a relatively small effect on exhaust temperature but greatly affects the flow velocity and NOx and THC emissions. Increasing the content of Pt in the catalyst can improve the THC conversion efficiency. For low Pt and Pd-Rh catalysts, the THC conversion effect is significantly deteriorated. The content of Rh affects the NOx conversion, and NOx conversion efficiency at high speeds is significantly reduced when Rh content is reduced. Higher carrier pore density can slightly improve the catalytic reaction rate and emission conversion efficiency at high engine speeds. However, high conversion efficiency can be maintained even after aging.