Search

• Internal fault detection from phase angles of negative sequence currents. • Phasor diagram of internal fault detection. • Fault location method. 1–26 Double-circuit transmission lines are used in modern power systems to enhance the transmission capability and to improve system reliability and safety. However, the protection of double-circuit lines is a challenging task as the presence of flexible ac transmission system (FACTS) in modern power grid impairs the performance of the conventional distance protection schemes. Moreover, the high impedance faults cannot be detected by relays as they become under-reach. This paper proposes a negative sequence current based scheme for locating faults and identifying faulty circuit/ line in double circuit transmission line compensated by UPFC at one end. In the proposed scheme the current signals are collected from both ends of the line to be protected. Then the negative sequence components of the currents are calculated. The discrimination between internal and external fault is achieved from the phase angles of the negative sequence currents and the fault location is determined from the ratio of the negative sequence currents. Prior knowledge about the type of fault is not required for fault location estimation. Extensive fault simulation studies including high impedance faults have been performed. The scheme is immune to the fault inception angle and fault resistance. [ABSTRACT FROM AUTHOR]

• Protective relaying scheme of UPFC compensated transmission line. • Fault detection using complex power of two end of the line. • Segregation of internal and external fault. • Localization of internal fault using sequence component of voltage and current signal. This study presents an integrated approach for discrimination of internal and external fault, and to obtain pin-point location of the fault in a transmission line connected to unified power flow controller (UPFC). To detect internal fault, this method uses positive sequence component of voltage and current at the local and remote end bus. Fault location estimation technique requires both positive and negative sequence voltage and current components measured from both ends of the line. The performance of the proposed technique has been evaluated by simulating a 400 kV double circuit UPFC compensated transmission line. This technique can detect internal fault under stressed conditions, viz. high impedance fault (HIF), change in source strength, change in load angle, and power swing. Precise fault location has been achieved under wide variation of system and fault parameters. The comparative assessment has been provided to prove the efficacy of the proposed approach. [ABSTRACT FROM AUTHOR]