Search

• Protective relaying scheme for long transmission line. • Fault detection using positive sequence admittance of two-ends of the line. • Segregation of internal and external fault. • Localization of internal fault using positive sequence fault components. In this paper, a novel integrated approach of protective relaying methodology has been adopted for detecting faults and its location estimation in long transmission line. First, the detection algorithm has been formulated using positive sequence admittance. Subsequently, fault location algorithm has been developed using positive sequence voltage and current phasors. The proposed algorithms have been implemented on a 50 Hz, 400 kV single-circuit transmission line in MATLAB environment. A wide range of diversified and challenging cases have been simulated to test the reliability of this scheme. The results confirm the preciseness of the algorithm, as it can produce accurate results under stressed conditions, viz. high impedance fault (HIF), current transformer (CT) saturation/ capacitive voltage transformer (CVT) transient, close-in faults, swing condition, source strength variation, etc. Moreover, this scheme has also been successfully tested in series-compensated and double-circuit transmission line, which brings out the superiority of this scheme. The comparative analysis with recent protective relaying techniques institutes the potentiality and robustness of the scheme. [ABSTRACT FROM AUTHOR]

• Internal fault detection from phase angles of negative sequence currents. • Phasor diagram of internal fault detection. • Fault location method. 1–26 Double-circuit transmission lines are used in modern power systems to enhance the transmission capability and to improve system reliability and safety. However, the protection of double-circuit lines is a challenging task as the presence of flexible ac transmission system (FACTS) in modern power grid impairs the performance of the conventional distance protection schemes. Moreover, the high impedance faults cannot be detected by relays as they become under-reach. This paper proposes a negative sequence current based scheme for locating faults and identifying faulty circuit/ line in double circuit transmission line compensated by UPFC at one end. In the proposed scheme the current signals are collected from both ends of the line to be protected. Then the negative sequence components of the currents are calculated. The discrimination between internal and external fault is achieved from the phase angles of the negative sequence currents and the fault location is determined from the ratio of the negative sequence currents. Prior knowledge about the type of fault is not required for fault location estimation. Extensive fault simulation studies including high impedance faults have been performed. The scheme is immune to the fault inception angle and fault resistance. [ABSTRACT FROM AUTHOR]