Search

This paper presents an optimal cascaded three degree of freedom proportional integral (3DOF PI) controller and compares its performance with conventional proportional integral (PI) controller for load frequency control of two area deregulated power system. The 3DOF PI controller enhances the degree of freedom and gives better dynamic response. Genetic algorithm (GA) is used to get the optimal gains of the proposed controllers. In the considered two area thermal-gas-fuel cell system, the thermal system consists of a reheat turbine with appropriate generation rate constraint non linearity. Battery storage and unified power flow controller (UPFC) are also assumed to be present. The performance of the proposed controllers is evaluated under different operating conditions that take place in deregulated power market. To tackle any contract violation this article emphasizes on the ancillary services provided by electric vehicles (EVs) and distributed generations. A robustness analysis is also presented by varying parameters from their nominal values. [ABSTRACT FROM AUTHOR]

• Internal fault detection from phase angles of negative sequence currents. • Phasor diagram of internal fault detection. • Fault location method. 1–26 Double-circuit transmission lines are used in modern power systems to enhance the transmission capability and to improve system reliability and safety. However, the protection of double-circuit lines is a challenging task as the presence of flexible ac transmission system (FACTS) in modern power grid impairs the performance of the conventional distance protection schemes. Moreover, the high impedance faults cannot be detected by relays as they become under-reach. This paper proposes a negative sequence current based scheme for locating faults and identifying faulty circuit/ line in double circuit transmission line compensated by UPFC at one end. In the proposed scheme the current signals are collected from both ends of the line to be protected. Then the negative sequence components of the currents are calculated. The discrimination between internal and external fault is achieved from the phase angles of the negative sequence currents and the fault location is determined from the ratio of the negative sequence currents. Prior knowledge about the type of fault is not required for fault location estimation. Extensive fault simulation studies including high impedance faults have been performed. The scheme is immune to the fault inception angle and fault resistance. [ABSTRACT FROM AUTHOR]