Search

A specific CE-MS method was developed for the simultaneous determination of 12 antibacterial residues (four sulfonamides: sulfamethazine, sulfathiazole, sulfadiazine, and sulfachlorpyridazine; four beta-lactams: amoxicillin, ampicillin, oxacillin, and penicillin V, and four quinolones: danofloxacin, enrofloxacin, ofloxacin, and flumequine) in fish and livestock. Separation conditions, sheath liquid composition and electrospray parameters were optimized to obtain adequate CE separation and a high sensitivity. CE employed a 75 cm long fused-silica capillary (50 cm thermostated plus 25 cm at room temperature) 75 microm id and a 60 mM ammonium acetate separation buffer at pH 8 with 10% of methanol. The minimum number of identification points, according to the 2002/657/EC European Decision, was achieved using an IT in multiple reaction monitoring (MRM) mode. For quantification in meat and fish samples, a two-step procedure was developed using ACN to extract the antibacterials and to precipitate the proteins and dispersive SPE, with C18 to clean up the extract. External matrix matched calibration curves were used to achieve accurate quantitative results. The LODs and LOQs (below 18 and 50 ng/kg, respectively) were in all cases lower than the maximum residue limits for these compounds in meat and fish. The recoveries ranged from 78 to 97% and the precision with RSDs lower than 18% indicate the potential of CE-MS for the analysis of multiclass antibacterial residues in food. The method was applied to meat and fish samples taken from markets, slaughterhouses, and fish farms.

A specific pressure-assisted CE-MS method is described for the analysis of five quinolone residues. MS using a single quadrupole is compared with multiple-stage MS using a quadrupole IT (QIT-MS(n)). The procedure involves a common sample preparation by SPE on disposable cartridges. The most suitable electrolyte is 60 mM (NH(4))(2)CO(3) at pH 9.2. Single quadrupole does not provide enough fragmentation to confirm identities according to the current legislation. However, QIT-MS(n) achieves selective fragmentation. Using this method, danofloxacin, enrofloxacin, flumequine, ofloxacin, and pipemidic acid are analyzed in fortified samples of chicken and fish. Recoveries at levels of 50 ng/g were 62-99%, except for flumequine, which gives recoveries > or =45%. RSDs are from 9 to 16% and the LOD is equal (20 ng/g) for the five analytes. Confirmation of the quinolones' identity is achieved using QIT-MS(3). Forty samples of chicken and fish taken from different local markets are analyzed. Enrofloxacin is also determined in incurred chicken muscle using this method.

A multiresidue analytical method based on solid-phase extraction (SPE) enrichment combined with capillary electrophoresis (CE), using micellar electrokinetic capillary chromatography (MEKC), was developed to determine ten substituted urea pesticides in orange and tomato samples. Several factors such as pH, composition and concentration of the buffer, concentration of surfactant, addition of organic solvent, and working voltage were optimized to obtain the best compound separation in the shortest time. Separation can be achieved in 7 min using a micellar aqueous pH 9 buffer composed of 4 mM borate and 35 mM sodium dodecyl sulfate. After an SPE procedure, which provided a 10-fold enrichment, the limit of detection was about 0.05 mg kg(-1), which is in the order of the maximum residue limits (MRLs) established by the European Union (EU) for most of these compounds. Increasing the enrichment factor by using a larger amount of sample is difficult in oranges due to the matrix interferences, but is possible in tomatoes, which gave cleaner extracts and easily reached a 25-fold enrichment factor. The procedure involving SPE and CE provided acceptable recoveries (ranged 42-118%) and relative standard deviations (RSDs; < 19%) at levels between 0.3 and 5 mg kg(-1).

Food contamination continues to be a serious problem around the world. Surveillance of chemical contaminants in foods is important not only for public health but also because of the negative economic impact of contamination. From the analytical perspective, analysis of contaminants in food is an extremely challenging area. There is a wide variety of questions, ranging from the quantification of extremely low levels of individual components to the detailed assessment and evaluation of the analytical technique possibilities. This review considers the applications of CE coupled to MS detection (CE-MS) for the analysis of organic contaminants in food. Analytical information on sample concentration techniques, as well as on the CE separation conditions and recoveries obtained from water and food are provided. Different sections include several fields of application, such as pesticides, drug residues, or toxic formed during food processing in different matrices. A number of tables report a comprehensive listing of CE-MS applications. As a result, this work presents an update overview on the principal application of CE-MS together with a discussion of their main advantages and drawbacks, and an outline of future trends on analysis of organic contaminants.

A method to identify and quantify six pesticide residues - dinoseb, pirimicarb, procymidone, pyrifenox, pyrimethanil, and thiabendazole - in peaches and nectarines using capillary electrophoresis-electrospray ionization-quadrupole ion trap-tandem mass spectrometry (CE-ESI-MS/MS) is described. Separation was carried out using a buffer of 0.3 M ammonium acetate at pH 4 with 10% methanol. Pesticide residues present in peach and nectarine samples were preconcentrated by solid-phase extraction using C(18), eluted with CH(2)Cl(2), concentrated to dryness, and redissolved in buffer to obtain lower detection limits. The recoveries of the analytes ranged from 58 to 99% and the relative standard deviations were 9 to 19%. Under optimized CE-MS/MS conditions the minimum detectable levels for the six pesticides in spiked peach samples were between 0.01 mg/kg for pirimicarb and 0.05 mg/kg for procymidone with pressure injection of 50 mbar for 5 s (5 nL) at a signal-to-noise ratio of 3, which constitutes a severalfold increase in sensitivity compared to CE-MS, using a single quadrupole, and to conventional CE-UV. The potential of the method was demonstrated by analyzing different samples taken from regional agricultural cooperatives. The pesticides most often detected were thiabendazole and procymidone.