Search

Thermally reversible Pluronic gels have been employed as separation matrices in microfluidic devices in the analysis of biological macromolecules. The phase of these gels can be tuned between liquid and solid states using temperature to vary fluidic resistance and alter peak resolution. Although separations in thermal gels have been characterized, their effect on isotachophoresis has not. This study used fluorescein as a model analyte to evaluate isotachophoretic preconcentration as a function of thermal polymer concentration and temperature. Results demonstrated that increasing polymer concentration in microfluidic channels increased the apparent analyte concentration. A critical minimum of 10% (w/v) Pluronic was required to achieve efficient preconcentration with maximum focusing occurring in 20 and 25% polymer gels. Temperature of the thermal gel also impacted analyte focusing. Most efficient focusing was achieved at 25°C with diminishing analyte accumulation at higher and lower temperatures. Under optimal conditions, isotachophoretic preconcentration increased an additional threefold simply by including thermal gels in the system. This approach can be readily implemented in other applications to increase detection sensitivity and measure low-concentration analytes within simple microfluidic devices.

Gel electrophoresis is a ubiquitous bioanalytical technique used to characterize the components of cell lysates. However, analyses of bulk lysates sacrifice detection sensitivity because intracellular biomolecules become diluted, and the liberation of proteases and nucleases can degrade target analytes. This report describes a method to enrich cells directly within a microfluidic gel as a first step toward online measurement of trace intracellular biomolecules with minimal dilution and degradation. Thermal gels were employed as the gel matrix because they can be reversibly converted between liquid and solid phases as a function of temperature. Rather than fabricate costly heating elements into devices to control temperature-and thus the phase of the gel-Joule heating was used instead. Adjoining regions of liquid-phase and solid-phase gel were formed within microfluidic channels by selectively inducing localized Joule heat. Cells migrated through the liquid gel but could not enter the solid gel-accumulating at the liquid-solid gel boundary-whereas small molecule contaminants passed through to waste. Barriers were then liquified on-demand by removing Joule heat to collect the purified, non-lysed cells for downstream analyses. Using voltage-controlled Joule heating to regulate the phase of thermal gels is an innovative approach to facilitate in-gel cell enrichment in low-cost microfluidic devices.

Methylarginines (MAs) are potent vasoconstrictors that have been reported to be present at elevated concentrations in the blood of patients suffering from cardiovascular disease (CVD). To determine the diagnostic potential of MAs for CVD, a method capable of rapidly quantifying their endogenous concentrations from serum samples is required. To that end, a heat-assisted extraction method was developed. Serum was first rapidly heated, causing it to congeal into a gel, and then subjected to solid-liquid extraction. The extraction solution was then derivatized with a fluorogenic dye and analyzed by CE-LIF to permit quantitation of the MAs. This heat-assisted extraction procedure allowed a no-net-dilution extraction of the analytes to be performed into a solvent compatible with the subsequent CE analysis. This enabled direct detection of low abundance analytes, such as MAs, without the need for a preconcentration step. This sample preparation method was compared with a commonly used solid-phase extraction method for MA analysis. Endogenous MA concentrations determined by both the heating and SPE methods were found to be in good agreement with each other and with values previously reported in the literature.