Search

A ground-coupled heat pump (GCHP) system used to provide the space heating for an office room is a renewable, high performance technology. This paper discusses vapour compression-based HP systems, briefly describing the thermodynamic cycle calculations, as well as the coefficient of performance (COP) and CO2 emissions of a HP with an electro-compressor and compares different heating systems in terms of energy consumption, thermal comfort and environmental impact. It is focused on an experimental study performed to test the energy efficiency of the radiator or radiant floor heating system for an office room connected to a GCHP. The main performance parameters (COP and CO2 emissions) are obtained for one month of operation of the GCHP system, and a comparative analysis of these parameters is presented. Additionally, two numerical simulation models of useful thermal energy and the system COP in heating mode are developed using the Transient Systems Simulation (TRNSYS) software. Finally, the simulations obtained from TRNSYS software are analysed and compared to the experimental data, showing good agreement and thus validating the simulation models. [ABSTRACT FROM AUTHOR]

Ground-coupled heat pumps (GCHPs) are an efficient thermal energy production system that can satisfy the gap between heating and air-conditioning. Be that as it may, exploratory research on GCHPs is still lacking. The first objective of this article is to describe a utilitarian energy-efficiency improvement device for a vertical GCHP system that includes a buffer tank (BT) between the heat pump unit and the fan coil units and user supply, utilizing the quantitative regulation of water flow rate with a variable-speed circulation pump. At that point, the investigative estimations are utilized to test the performances of the GCHP system in various operating modes. Fundamental efficiency parameters (coefficient of performance (COP) and CO2 emission) are achieved for one month of running utilizing two control strategies of the GCHP—standard and optimized regulation of the water pump speed—and a benchmarking of these parameters is achieved. Exploratory research has indicated higher efficiency of the system for the flow regulation solution utilizing a BT and programmed control equipment for the circulation pump speed compared with the standard regulation solution (COPsys with 7–8% higher and CO2 emission level 7.5–8% lower). The second objective is to elaborate a simulation model of the necessary heat/cold in heating and air-conditioning periods, utilizing the Transient Systems Simulation (TRNSYS) program. Finally, the simulation, acquired utilizing the TRNSYS program, is analyzed and compared with experimental information, leading to a good agreement and, along these lines, the simulation model is approved. [ABSTRACT FROM AUTHOR]